James Loudspeakers SPL5 FLAT Руководство по установке
Просмотреть онлайн или скачать pdf Руководство по установке для Стойки и подставки James Loudspeakers SPL5 FLAT. James Loudspeakers SPL5 FLAT 2 страницы. Mounting bracket
Печатать страницуPart A (Pre-Assembled)
(2) Fixed brackets, (2) Sliders,
(2) Short swivel joints (part B),
(2) Long swivel joints (part C)
1
Place the display on a padded flat surface.
Position SoundBar evenly below the display.
4
SPL5
®
Installation guide for James Loudspeakers SPL5 SoundBar series universal mounting bracket.
Part B
Part C
(2) Additional
(2) Additional
Short
Swivel Joint
Swivel Joint
Part T1
Part F1
(2) Tilt Mounts
(2) Flat Mounts
2
Loosen screws on bracket (Part A) and
pre-assembled swivel joints, so that they
can slide/pivot with little resistance.
Swivel Joint should rest on the top of the
5
SoundBar. Secure and position flat mount
and spacer (Part F1 & F2) to align with
VESA through-hole pattern on the TV. Use
8-32 x 3/8˝ Phillips flat head screws (Part
T2).
FLAT
MOUNTING BRACKET
INSTALLATION GUIDE
Long
Part F2
(2) Flat Mount
Spacers
BRACKETS SUPPLIED HARDWARE
Part QTY
Screws
E
28
Round Spacers (1.25˝ x 0.125˝)
G
4
M8-50mm Pan Head Philips Screws
4
M8-45mm Pan Head Philips screws
4
M8-35mm Pan Head Philips screws
H
4
M6-50mm Pan Head Philips Screws
4
M6-45mm Pan Head Philips screws
4
M6-35mm Pan Head Philips screws
J
4
UNC 1/4-20˝ Pan Head Philips Screws
4
UNC 1/4-20˝ Hex Nuts
TV MOUNT SUPPLIED HARDWARE
Part QTY
Screws
8
No. 12 Wood Screws 1.75˝ Phillips Screws
T2
4
UNC 8-32 x 3/8˝ Flat Head Philips Screws
4
UNC 8-32 x 3/4˝ Flat Head Philips Screws
Determine the amount of spacers
3
needed (Part E). With or without the
spacer on the VESA pattern, the bracket
and slider should slide up and down
without interference from the SoundBar
or any protrusions on the rear of the
display.
Determine the screw size, M6 or M8,
6
required to mount your wall bracket to
the display. Select either the M6 (Part H)
or M8 (Part G ) hardware bag. 3 lengths
are provided, 35mm, 45mm, and 50mm.
Select the correct length to match the
spacer quantity (height), so the screw
properly holds the brackets and mount to
the display.