BEROTEC CUMPAN Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Аксессуары для мотоциклов BEROTEC CUMPAN. BEROTEC CUMPAN 9 страниц. Ktm exc 250-f exc 350-f 250 exc tpi 300 exc tpi / husqvarna fe 250 te 300i fe 350 tx 300i te 250i / gasgas ec 250f ec 300 ec 350f ex 250 ec 250 ex 300
Также для BEROTEC CUMPAN: Руководство пользователя (8 страниц), Руководство пользователя (8 страниц), Руководство пользователя (4 страниц), Руководство пользователя (4 страниц), Руководство пользователя (4 страниц)

INSTALLATION

E l e c t r i c a l c o n n e c t i o n

Power cable: red to switched +12V / black to ground. Often already prepared on

the vehicle (e.g. for a navigation device, called „ACC2" at KTM), otherwise the pow-

er supply of the light / horn is used for this. Current requirement: 80 mA / 12V.

RPM signal: connect black (single) cable to the signal of the crankshaft position sen-

sor. To do this, you need to locate the cable of the sensor. As a rule, this can be found

on the alternator.

Do not lay the cable in the direct vicinity of the ignition system

Engine temperature: Connect the plug to the sensor. The temperature sensor

must be screwed in/ installed in the area of the desired temperature detection.

IN 1: Analog input 1 (black and white cable), input voltage 0-5V

IN 2: Analog input 2 (black and blue cable), input voltage 0-5V

The following sensors/signals can be connected to inputs „IN 1" and „IN 2" respectively:

» Gear indicator („GEAR")

» Oil pressure („PRESSURE")

» Lambda probe („LAMBDA"/„AFR")

» Second temperature sensor („MOTORTEMP2")

Note: The information „PRESSURE", „LAMBDA", „AFR" or „MOTORTEMP2" can only be di-

splayed in conjunction with the optionally available additional modules.

If no signal is connected, the input must be set to „None" in the Input menu.

Attention: The input voltage (0-5V) from the analog inputs must be observed. Higher vol-

tages destroy the device!

English