Makita BJV140 Руководство по эксплуатации - Страница 9
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Makita BJV140. Makita BJV140 13 страниц. Cordless jig saw
Также для Makita BJV140: Руководство по эксплуатации (13 страниц), Руководство по эксплуатации (13 страниц), Техническая информация (13 страниц), Руководство по эксплуатации (18 страниц)
Печатать страницу
Bevel cutting
007488
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before tilting the base.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the bevel slot in the base.
2
1
007489
Tilt the base until the desired bevel angle is obtained.
The V-notch of the gear housing indicates the bevel
angle by graduations. Then tighten the bolt firmly to
secure the base.
1
3
2
007490
Front flush cuts
2
1
007491
1. Base
3
2. Bolt
3. Hex wrench
1. Bevel slot
2. Base
6
3. Bolt
5
4. Graduations
5. V-notch
4
6. Gear housing
1. Base
3
2. Bolt
3. Hex wrench
Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then tighten
the bolt to secure the base.
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole:
007492
For internal cutouts without a lead-in cut from an
•
edge, pre-drill a starting hole 12 mm or more in
diameter. Insert the blade into this hole to start your
cut.
B) Plunge cutting:
007493
You need not bore a starting hole or make a lead-in
•
cut if you carefully do as follows.
1.
Tilt the tool up on the front edge of the base with
the blade point positioned just above the
workpiece surface.
2.
Apply pressure to the tool so that the front edge of
the base will not move when you switch on the tool
and gently lower the back end of the tool slowly.
3.
As the blade pierces the workpiece, slowly lower
the base of the tool down onto the workpiece
surface.
4.
Complete the cut in the normal manner.
Finishing edges
007494
9
1. Starting hole
1