Makita BTL060Z Техническая информация - Страница 4

Просмотреть онлайн или скачать pdf Техническая информация для Электроинструмент Makita BTL060Z. Makita BTL060Z 9 страниц. Cordless angle impact drivers 14.4v/ 18v

Печатать страницу

epair

[3] DISASSEMBLY/ASSEMBLY

[3] -1. Angle Head Complete

DISASSEMBLING

1) Angle head complete can be removed from Housing simply by unscrewing (+) Hex bolt M5x30.

Note: If the overlapping portion of Angle head complete is deformed from abuse or a fall, Angle head complete cannot

be removed from Housing by hand. In this case, remove it while expanding the slit between the bolt holes

with a slotted screwdriver. (Fig. 2)

2) Remove Retaining ring R-26 using 1R005.

3) By striking Angle head complete straight against a flat surface of work bench or the like, the following parts can be

removed as an assembly (Fig. 3):

Zerol bevel gear 13, Ball bearing 6000, Sleeve 10, Ball bearing 6000LLB, Retaining ring S-10

4) Remove Retaining ring S-10 using 1R291, then two Ball bearings using 1R269.

5) Remove Rubber ring 32 from Angle head complete, then remove Retaining ring R-28 using 1R291.

6) Spindle section can now be removed by tapping Angle head complete.

Note: Spindle section cannot be removed if Angle head complete is deformed from abuse or a fall.

In this case, attach an appropriate bit on Angle head complete, then clamp the bit securely in a vise.

Spindle section can now be removed by tapping Angle head complete with plastic hammer as illustrated in Fig.. 4.

7) Spindle section can be disassembled as described in Fig. 5.

Fig. 2

bolt hole

Angle head complete

Fig. 5

1) Remove Ring spring 9 from Spindle

by taking the following steps:

Insert an awl between the teeth of Spindle

into Ring spring 9.

Note: Insert into the space on the opposite

side of the ends of Ring spring 9.

Hook Ring spring 9 by moving the awl

in the direction of the arrow.

Note: Ring spring 9 will be deformed when

removed from Spindle.

Be sure to use new one for assembling

Zerol bevel gear 13

Ball bearing 6001DDW

Fig. 3

Angle head complete

assembly consisting of

Zerol bevel gear 13, etc

teeth of Spindle

ends of Ring spring 9

Fig. 4

vise

bit

2) Remove Zerol bevel gear 13 from Spindle

by striking Spindle straight against a flat

surface of work bench or the like.

If cannot be removed, remove together with

Ball bearing 6001DDW using 1R269

as illustrated below.

Spindle

Zerol bevel gear 13

Ball bearing 6001DDW

P 4/ 9

Angle head complete

1R269