Garde 181FC38 Руководство пользователя - Страница 2

Просмотреть онлайн или скачать pdf Руководство пользователя для Фреза Garde 181FC38. Garde 181FC38 4 страницы. French fry cutters

Please read and comply with the instructions listed on this document. To get the best service life

and performance from your machine, clean it thoroughly before and after each use by following the

instructions listed below. Minimize the use of alkaline cleaners as they may dull the finish and cause pitting.

Safety Instructions

Be careful when handling and operating the machine, as the blades are very sharp. Always

keep your hands away from the blades.

Preparation

These fry cutters can be mounted to a countertop, workstation, or wall.

1. Wall Mount Instructions:

a. Place the unit where you'd like it to be mounted.

b. Find the closest stud and move the machine so that the mounting holes on one side of the

unit are over the stud.

• It's important that the unit be mounted to a stud to prevent it from falling during use!

c. Mark the 4 hole locations and remove the machine.

d. Drill 5/32" holes through these marks and then, with washers under their heads, drive the

mounting screws through the holes in the unit and into the holes in the wall.

2. Countertop/Workstation Instructions:

a. Choose a sturdy countertop or workstation for mounting.

b. Place the unit where you'd like it to be mounted.

c. Mark the 4 hole locations and remove the machine.

d. Drill 5/32" holes through these marks and then, with washers under their heads, drive the

mounting screws through the holes in the unit and into the holes in the surface.

Operation

1. Put a potato on the blade and holder assembly.

2. After making sure your hands and fingers are clear of the cutting area, pull the handle in one quick

motion.

a. This may occasionally need to be repeated for potatoes that are exceptionally large.

b. Do not try to cut potatoes that are bigger than the opening in the blade holder.

3. When finished, be sure to clean the machine using the instructions below.

Note: to cut 1/4" and 1/2", use the 1/4" push block. To cut 3/8", use 3/8" push block.

USER MANUAL