Avanti WID260P Руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Диспенсер для воды Avanti WID260P. Avanti WID260P 16 страниц. Water dispenser with ice maker
Печатать страницуIMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF
THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS
SERVICE CENTER.
Before Using Your Water Dispenser
•
Check to be sure the following parts are included:
Instruction manual
Plastic Ice Scoop
•
Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
•
The water dispenser is pre-cleaned at the factory but the reservoir and water lines must be flushed
with fresh water before use as follows:
•
Keep the unit unplugged.
•
Fill water tank with tap water full to capacity. Wait for 5 minutes until water settles.
•
Turn the child safety button then push the hot water faucet until water comes out, then stop.
•
Plug the dispenser into the electrical outlet. We are ready to complete the first cycle. In order to
do that, wait for the hot water to reach temperature in approximately 10 minutes, and then wait for
the cold to reach temperature (another 40 minutes, approximately).
•
Unplug the dispenser from the electrical outlet. Proceed to drain the water from the faucets one at
a time until no more water remains.
(Note: To facilitate this operation, use a large container).
•
Then, drain any water left in the tanks by opening the drain plug located on the back, until it drains
completely.
•
Proceed to close the drain cap.
•
Remove the cap from the 3 or 5-gallon bottle and use a clean cloth to wipe off the neck of the
bottle.
•
Place the 3 or 5-gallon bottle of water on the water intake, allow water to stand for approximately
one minute.
•
Push water faucet buttons to insure water flows from each of the faucets.
•
Plug dispenser back into the electrical outlet.
•
Now you are ready to use your water dispenser.
NOTE: Your water dispenser has been cleaned and sanitized before leaving the
factory, but in case a taste problem develops, place two tablespoons of
baking soda and add tap water. Fill water tank again and repeat basic
operations previously outlined, except turn hot water function "OFF" to
avoid leaving residues in hot water tank.
ATTENTION:
If you do not plan to use the water heating function for more than three days, we
recommend that you turn off the hot water function.
WARNING
INITIAL PRODUCT SET-UP
7