Corsa 14247 Инструкция по установке - Страница 3

Просмотреть онлайн или скачать pdf Инструкция по установке для Вентиляционная вытяжка Corsa 14247. Corsa 14247 4 страницы. Cat-back exhaust system for chevrolet avalanche 2007; chevrolet avalanche 2008; chevrolet suburban 2007; chevrolet suburban 2008; gmc yukon xl 2008; gmc yukon xl 2007; chevrolet tahoe 2007; chevrolet tahoe 2008; gmt900 2008; gmt900 2007

Печатать страницу

Installation of CORSA Exhaust System:

NOTE: Apply the anti-seize lubricant (supplied) to the threads ONLY of all the clamps

and flange bolts. Failure to follow this procedure can cause nuts to seize on clamps

and potentially destroy threads. After applying anti-seize lubricant, be sure to

thoroughly clean hands as lubricant will tarnish stainless steel. All clamps should

be tightened using a properly calibrated Torque Wrench. Using an air impact gun

will damage the clamp and reduce its ability to effectively seal the joint. It may

also cause the joint to separate thereby causing damage to your exhaust system

and your vehicle.

1) Locate the CORSA Head Pipe assembly and slide the flange over the studs on the factory

flange. Use the nuts supplied with the CORSA hardware kit and tighten down to 30 Ft-lbs.

Insert the hanger in to the factory grommet. (See Fig's K, L & M)

Note: Using a soapy solution on the grommet hole will make the job easier.

2) Slide a supplied 3" TORCA clamp over the inlet of the CORSA muffler. Make sure the drain

hole is facing down. Slide the muffler onto the Head Pipe and pre-tighten the clamp.

(See Fig's N, O & P)

3) Slide a supplied 3" TORCA clamp over the inlet of the CORSA Tailpipe. From the rear of the

vehicle slide the pipe over the axle while holding the rear differential vent hose out of the way.

Insert the pipe over the muffler exit and place the hangers into the factory grommets.

(See Fig's Q, R, S, T & U)

FIG. K

FIG. O

FIG. L

FIG. P

Exhaust System Installation: Cat-Back Exhaust System

2007-08 Avalanche/Suburban/Yukon XL 5.3L GMT900

Single Side Exit

Twin Pro-Series 4.0" Tips / SPORT PN 14246 / TOURING PN 14247

Hydroformed Oval Tip / SPORT PN 14248 / TOURING PN 14249

FIG. M

FIG. Q

C L A M P

Position slot

90° off of bolt

Position

clamp at

expanded

FIG. N

FIG. R

end of

tube