Makita DJV184RTJ Руководство по эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Makita DJV184RTJ. Makita DJV184RTJ 17 страниц.

Bevel cutting

CAUTION:

Always be sure that the tool is

switched off and the battery cartridge is removed

before tilting the base.

With the base tilted, you can make bevel cuts at any

angle between 0° and 45° (left or right).

Fig.12

Loosen the bolt on the back of the base with the hex

wrench. Move the base so that the bolt is positioned in

the center of the cross-shaped slot in the base.

Fig.13

► 1 . Hex wrench 2. Bolt 3. Base

Tilt the base until the desired bevel angle is obtained.

The edge of the motor housing indicates the bevel

angle by graduations. Then tighten the bolt to secure

the base.

Fig.14

► 1 . Edge 2. Graduation

Front flush cuts

Fig.15

► 1 . Hex wrench 2. Bolt 3. Base

Loosen the bolt on the back of the base with the hex

wrench and slide the base all the way back. Then

tighten the bolt to secure the base.

Cutouts

Cutouts can be made with either of two methods

"Boring a starting hole" or "Plunge cutting".

Boring a starting hole

Fig.16

For internal cutouts without a lead-in cut from an edge,

pre-drill a starting hole 12 mm or more in diameter.

Insert the jig saw blade into this hole to start your cut.

11 ENGLISH