Corsa 14255 Руководство по установке

Просмотреть онлайн или скачать pdf Руководство по установке для Вентиляционная вытяжка Corsa 14255. Corsa 14255 6 страниц. Twin pro series 4" exhaust system for chevrolet ssr 2004; chevrolet ssr 2005; chevrolet ssr 2006

Печатать страницу

CHEVY SSR

Exhaust System Installation

2004-06 Chevrolet SSR

PN 14254 / PN 14255

TOOLS NEEDED: Safety glasses, 15 mm wrench or deep socket, 1/2" wrench or deep socket,

Torque wrench, saw or cutting wheel, chain-style pipe cutter, soapy water solution, ruler and

black marking pen

All Torca clamps should be tightened using a

properly calibrated Torque Wrench. Using an air

impact gun will damage the clamp and reduce its

ability to effectively seal the joint. It may also cause

the joint to separate thereby causing damage to

your exhaust system and your vehicle.

INSTALLATION NOTE:

Be sure to apply the provided anti-seize lubricant

to all bolts, fasteners and clamps. A pouch is

included with the hardware kit. Apply the supplied

anti-seize lubricant to the threads ONLY of all

TORCA band clamps. Failure to follow this

procedure can cause the nuts to seize on clamps

and potentially damage threads.

sure to thoroughly clean hands after use. Anti-

seize lubricant will tarnish stainless steel parts.

CAUTION:

Prior to installation, be sure your vehicle

is parked on a level surface, and the exhaust

system is cool. For safety purposes and ease of

installation, we urge you to take your vehicle to a

qualified service center or muffler installer that

employs the use of a lift.

2004 Removal Instructions:

1) Scribe line approximately 2-3 inches down from frame brace (passenger

side). See Fig. A

2) Cut pipe as far upward as possible toward the "Y" section (passenger

side). See Fig. B

3) After cutting through pipe, remove passenger side segment as shown

in Fig. C.

4) Cut the driver side stock pipe as close as possible to spot indicated by

arrow in Fig. D.

5) Cut the driver side pipe as indicated in Fig. E.

T O R C A

WARNING:

C L A M P

Position slot

90° off of bolt

Position

clamp at

end of

expanded

tube

FIG. A

FIG. B

FIG. C

FIG. D

FIG. E