Empire DVCC series Руководство для домовладельцев - Страница 4
Просмотреть онлайн или скачать pdf Руководство для домовладельцев для Крытый камин Empire DVCC series. Empire DVCC series 12 страниц. Direct vent zero clearance gas fireplace heater
Печатать страницу
INTERMITTENT PILOT LIGHTING INSTRUCTIONS (BP7 SERIES)
FOR YOUR SAFETY READ BEFORE LIGHTING
A.
This appliance has a pilot which can be lighted with the
manual on/off switch, a remote control, or by switching the
receiver switch to the "ON" position. When lighting the pilot,
follow these instructions exactly.
B.
BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What To Do If You Smell Gas
• Do not try to light any appliance.
• Do not touch any electrical switch;
• Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the
fire department.
1.
STOP! Read the safety information above.
2.
Turn OFF electric power to the appliance.
3.
Remove barrier screen.
4.
Turn gas supply knob counterclockwise
position.
5.
Wait ten minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas, STOP! Follow "B" in
the safety information above on this page. If you do not smell
gas, go to the next step.
6.
Turn ON electric power to the appliance.
7.
Find pilot - The pilot is behind the burner on the left side.
8.
Turn main flame to on. If the pilot does not light within 60
seconds, stop and go to Step 5.
1.
Turn off all electric power to the appliance if service is to be
performed (if applicable).
2.
Gain access to control compartment. Remove barrier
screen.
Page 4
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO FIREPLACE
WARNING
C. Use only the remote control or manual remote receiver
switch to operate the gas valve. Never use tools. If valve
does not operate, don't try to repair it, call a qualified ser-
vice technician. Force or attempted repair may result in a
fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
9.
Refer to remote control instructions for detailed information,
control features, and operation. Note: There is a CPI/IPI
switch that allows for a continuous standing pilot mode or an
to "On"
intermittent pilot mode. See manual for location of this switch. If
the pilot or burner does not stay lit (in the standing pilot mode),
stop and immediately call a qualified service technician or gas
supplier.
10. If the burner or pilot does not operate properly after several
tries, turn the gas supply knob clockwise
and call your service technician or gas supplier.
11. Replace barrier screen.
12. Operation of the gas valve is controlled by a manual on/
off switch or a hand held remote control. Refer to remote
instructions for detailed operation information.
3.
Locate On/Off gas supply knob and turn clockwise to
"OFF". Do not force.
4.
Replace barrier screen.
Figure 2
to "OFF"
37620-0-1116