Lexmark 25C0352 - C 734dtn Color Laser Printer Руководство по печати - Страница 3

Просмотреть онлайн или скачать pdf Руководство по печати для Принтер Lexmark 25C0352 - C 734dtn Color Laser Printer. Lexmark 25C0352 - C 734dtn Color Laser Printer 9 страниц. Color laser printers
Также для Lexmark 25C0352 - C 734dtn Color Laser Printer: Руководство по установке модуля лотка (1 страниц), Руководство по установке модуля лотка (2 страниц), Краткая справка (2 страниц), Руководство по подключению (5 страниц), Руководство по печати (3 страниц), Брошюра и технические характеристики (6 страниц), Руководство для СМИ (3 страниц), Карта меню (3 страниц), Руководство по снабжению (2 страниц), Установка (2 страниц), Информационный справочник (1 страниц), Информационный лист (4 страниц)

Печатать страницу
Lexmark 25C0352 - C 734dtn Color Laser Printer Руководство по печати

Color misregistration

Example
ABCDE
ABCDE
ABCDE
ABCDE
Adjusting the color alignment
1
Make sure that the printer is turned off.
2
From the printer control panel, press and hold
3
Release both buttons when the clock appears.
The printer performs its power-on sequence, and then Config Menu appears.
4
Press the down arrow button until
5
Press
again to print the alignment page.
6
Press the down arrow button until
7
From the printed sheet, find the straightest of the 20 lines beside the letter A.
8
Press the left arrow button or the right arrow button until that number is displayed, and then press
Submitting selection appears.
9
Repeat steps 6 through 8 to align sets A through L.
10
Press
.
11
Press
.
12
Press the down arrow button until
Resetting the Printer appears briefly, followed by a clock, and then Ready appears.
Cause
Color has shifted outside of the appropriate
area or has been superimposed over another
color area.
and the right arrow button while turning the printer on.
Color Alignment appears, and then press
Set A appears, and then press
Exit Config Menu appears, and then press
Print quality guide
Page 3 of 8
Solution
1
Recalibrate the printer.
•
Perform Color Adjust from the Quality
menu
2
Remove and reinstall the
photoconductor.
3
Adjust the color alignment. For more
information, see "Adjusting the color
alignment" on page 3.
Note: If you have not resolved the issue,
then recalibrate again. If necessary, adjust
the color alignment again.
.
.
.
.