KitchenAid YKFEG500ESS Руководство по установке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по установке для Диапазоны KitchenAid YKFEG500ESS. KitchenAid YKFEG500ESS 20 страниц. Freestanding
Также для KitchenAid YKFEG500ESS: Краткое руководство по эксплуатации (2 страниц), Руководство пользователя (18 страниц)
Печатать страницу
4. On Ranges Equipped with a Storage Drawer:
Remove the storage drawer. See the "Storage Drawer"
section. Use a ¼" drive ratchet to lower the rear leveling legs
one-half turn. Use a wrench or pliers to lower front leveling
legs one-half turn.
A
B
A. ¼" drive ratchet
B. Rear leveling leg
On Ranges Equipped with a Warming Drawer or Premium
Storage Drawer:
On ranges equipped with a warming drawer or premium
storage drawer, the rear leveling legs cannot be accessed by
removing the warming drawer or premium storage drawer. It
will be necessary to adjust the rear leveling legs from outside
the range. Use wrench or pliers to lower the front and rear
leveling legs one-half turn.
C
A
B
A. Rear leveling leg
B. Wrench or pliers
C. Front leveling leg
Install Anti-Tip Bracket
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
1. Remove the anti-tip bracket from where it is taped inside the
storage drawer or warming drawer.
D
C
C. Wrench or pliers
D. Front leveling leg
2. Determine which mounting method to use: floor or wall.
If you have a stone or masonry floor, you can use the wall
mounting method. If you are installing the range in a mobile
home, you must secure the range to the floor.
3. Determine and mark centerline of the cutout space. The
mounting bracket can be installed on either the left-hand side
or right-hand side of the cutout. Position mounting bracket
against the wall in the cutout so that the V-notch of the
bracket is 12⁹⁄₁₆" (31.9 cm) from centerline as shown.
Centerline
⁹⁄₁₆
A. 12
B. Bracket V-notch
4. Drill two ¹⁄₈" (3 mm) holes that correspond to the bracket
holes of the determined mounting method. See the following
illustrations.
Floor Mounting
Rear position
Front position
Wall Mounting
5. Using two #12 x 1⁵⁄₈" Phillips-head screws provided, mount
anti-tip bracket to the wall or floor.
6. Move range close enough to opening to allow for final
electrical connections. Remove shipping base, cardboard or
hardboard from under range.
7. Move range into its final location, making sure rear leveling
leg slides into anti-tip bracket.
B
A
" (31.9 cm)
Diagonal (2 options)
5