Jancy Engineering Slugger 2x2 17982 Руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сверло Jancy Engineering Slugger 2x2 17982. Jancy Engineering Slugger 2x2 17982 16 страниц. Slugger portable magnetic drilling machine
Печатать страницуRemove all contents from packaging and inspect to ensure no damage was incurred during shipping. Your 2x2 package
should include the following:
Assemble three spoke handles (item #404) to feed hub. NOTE: Feed hub assembly is mounted on right side of machine
frame – if necessary, it can be reversed for lefthand operation by simply removing the fastener (item #402) and hub (item
#401) from frame. Remove hub pinion shaft from right side of frame and insert it into left side of frame. Replace hub
and fastener into frame and tighten securely.
Install the arbor into the drill motor by inserting the arbor body into the spindle. By turning the arbor while inserting, the
arbor tang will properly line up in the spindle. The stop rod (item #911) should be between the inducer pin (item #904.3)
and the hose connection (item #904.2) when properly installed. Turn the arbor until it bottoms out in the spindle and
then tap lightly with a plastic hammer to secure.
To install coolant bottle, use bracket (item #611) to slide the coolant bottle onto the two retaining screws (item #614),
located on the right side of drill. Install the free end of hose onto hose connection (item #904.2) on the arbor.
1. Type of material to be drilled, Brinnell or Rockwell hardness, material thickness and position should all be determined
to ensure proper selection of Slugger cutting tools, RPM, coolant and drilling time.
2. Remove any excessive mill scale or rust from surface to be drilled.
3. Material that has been flame cut may have become heat-treated and therefore difficult to drill. Avoid drilling near
such areas whenever possible.
4. Drilling with the 2x2 in horizontal positions requires a special lubrication for Slugger cutters.
Consult Jancy Engineering for details.
operating instructions ( before you begin )
description
OPERATOR'S MANUAL
SHUNT INSTRUCTIONS
WARRANTY CARD
2.5 MM HEx KEY
4MM HEx KEY
5MM HEx KEY
6MM HEx KEY
8MM COMBINATION WRENCH
KNOB AND SPOKE HANDLE
SAFETY STRAP
KNOCK-OUT WEDGE
SAFETY AND MAINTENANCE CD
#2MT ARBOR ASSEMBLY
COOLANT BOTTLE ASSEMBLY
3/16" PILOT PIN 1" D.O.C.
3/16" PILOT PIN 2" D.O.C.
1/4" PILOT PIN 1" D.O.C.
1/4" PILOT PIN 2" D.O.C.
getting started
CAUTION!
2
2
always disconnect
x
from power source before making adjustments
what you should know before you drill
#
part
qty
LIT102B
1
06958
1
0070342
1
0151255
1
70587
1
70588
1
058112
1
0151219
1
07018
3
06798
1
07517
1
06814
1
07504
1
0151511
1
16001
1
16002
1
16003
1
16004
1
.
7