Empire VSM-18-1 Инструкции по установке и руководство пользователя - Страница 9
Просмотреть онлайн или скачать pdf Инструкции по установке и руководство пользователя для Крытый камин Empire VSM-18-1. Empire VSM-18-1 20 страниц. Vented slope glaze burner
Печатать страницуPlACeMeNT OF GlOWING eMbeRs ANd lAVA ROCK
Placement of the glowing embers (rock wool) is very individual and
light coverage of the areas indicated will provide your best effects.
We recommend separation of the rock wool by hand and make your
coverage as light and fluffy as possible.
Place just enough embers on the burner to obtain the glow and a
gold, yellow flame.
Do not place embers (rock wool) over large ports in rear portion
of burner.
Rock wool should not be placed in the area of the pilot assembly.
Placing lava Rock in Front of burner on Fireplace Floor
Spread lava rocks on fireplace floor in front of the burner pan. The
lava rocks are for decorative effect and are not required for fireplace
operation.
ATTENTIoN: DO NOT PLACE LAVA ROCKS ON BURNER,
LOGS OR ROCK WOOL. THE LAVA ROCKS SHOULD ONLY
BE PLACED ON THE FIREPLACE FLOOR.
OPeRATION INsTRuCTIONs/FlAMe APPeARANCe
Flames from the pilot (right back side of the pan burner) as well
as the main flame should be visually checked as the log set is
installed.
In normal operation at full rate after 10 to 15 minutes, the flame
appearance should be sets of yellow flames.
NOTICE: all flames will be random by design, flame height will go
up and down.
Avoid any drafts that alter burner flame patterns. Do not allow fans to
blow directly into fireplace. Do not place a blower inside the burner
area of the firebox. Ceiling fans may create drafts that alter flame
patterns. Sooting and improper burning will result.
During manufacturing, fabricating and shipping, various components
of this appliance are treated with certain oils, films or bonding agents.
These chemicals are not harmful, but may produce annoying smoke
and smells as they are burned off during the initial operation of the
appliance, possibly causing headaches or eye or lung irritation. This
is a normal and temporary occurrence.
The initial break-in operation should last 2-3 hours with the burner
at the highest setting. Provide maximum ventilation by opening
windows or doors to allow odors to dissipate. Any odors remaining
after this initial break-in will be slight and will disappear with
continued use.
26284-3-0813
Figure 5
Manual - Figure 6
Millivolt - Figure 7
Page 9