Empire BF-10BC-2 Инструкции по установке и руководство пользователя - Страница 18
Просмотреть онлайн или скачать pdf Инструкции по установке и руководство пользователя для Газовый обогреватель Empire BF-10BC-2. Empire BF-10BC-2 20 страниц. Unvented
Печатать страницуOPTIONAL BLOWER INSTALLATION INSTRUCTIONS (continued)
Wiring
The appliance, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes, with
the National Electrical Code, ANSI/NFPA 70, if an external electrical
source is utilized. This appliance is equipped with a three-prong
[grounding] plug for your protection against shock hazard and should
be plugged directly into a properly grounded three-prong receptacle.
Do not cut or remove the grounding prong from this plug. For an
ungrounded receptacle, an adapter, which has two prongs and a
wire for grounding, can be purchased, plugged into the ungrounded
receptacle and its wire connected to the receptacle mounting screw.
With this wire completing the ground, the appliance cord plug can
be plugged into the adapter and be electrically grounded.
Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
Blower Motor
The blower motor does not have oiling holes. Do not attempt to
oil the blower motor.
Blower Wheel
The blower wheel will collect lint and could require periodic cleaning.
If the air output decreases or the noise level increases, it indicates
a dirty blower wheel.
To clean blower wheel:
1.
Turn OFF gas supply to the heater.
2.
Turn OFF electrical supply to the heater.
3.
Remove lower louver from casing assembly (2 screws).
4.
Remove reflector from casing assembly (2 screws).
5.
Remove upper louver from casing assembly (2 screws).
6.
Clean blower wheel with a vacuum cleaner.
7.
As parts are being replaced in reverse order, check for gas
leaks at all gas connections before lower louver is replaced
onto casing assembly.
Unplugging of blower accessory will not stop the heater from cy-
cling. To turn off gas to the unvented heater: Push in gas control
knob slightly and turn clockwise to "OFF." Do not force.
Page 18
CAUTION
WARNING
If any of the original wire as supplied with the appliance must be re-
placed, it must be replaced with type 125°C wire or its equivalent.
PARTS LIST
INDEX
PART
NO.
NO.
DESCRIPTION
1
R-2396
BLOWER (INCLUDES MOTOR,
FAN, AND FAN HOUSING)
2
R-2503
FAN CONTROL
3
R-2395
WIRE ASSEMBLY
4
R-1468
BUSHING - HEYCO #SR5KN4
5
VF-068
CORD SET ASSEMBLY
6
SR-196 BLOWER PAN
7
R-1499
RUBBER GROMMET (4 RE-
QUIRED)
8
R-1454
BRASS BUSHING (4 REQUIRED)
N/S
SR-219 BLOWER HARDWARE PACKAGE
16013-6-0314