Empire Scion Руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Оборудование для пейнтбола Empire Scion. Empire Scion 11 страниц. Paintball loader system
Печатать страницу
EMPIRE® SCION™ LOADER INSTRUCTIONS
Battery Installation
• Remove the toolless battery door by sliding the tab toward the nose and lift the door up and
out of the loader.
• Remove the battery holder, by first removing the battery wire connector.
• Install (6) AA batteries following the polarity markings on the holder. Batteries not
included.
• Connect battery wire connector to the battery pack.
• Reinstall the battery pack. Make sure the wire is not between the battery pack and
compartment. Wire should be to the side.
• Reinstall the toolless battery door.
Attaching the Loader
Straight feedneck application: the loader will load directly into the feedneck (the loader
neck can be shaped with sandpaper if the neck is too wide to fit into your marker). Press the
Scion™ loader into the feedneck until it stops: align the loader parallel with the marker with
the lid towards the rear of the marker.
Loading the Loader
• Hold the loader from the back, with your thumb under the lip of the lid.
• Sweeping your thumb upward will pop the lid open.
• Load paintballs and close the lid. Leave space for the balls to move about.
OPERATING THE EMPIRE® SCION™
Your Empire® Scion™ loader uses a series of sensors and control systems to give fast,
consistent feeding speeds while being very gentle on paintballs. When the loader is turned on
it will immediately start feeding paintballs. If the loader is empty it will continue to run, but at
a slower speed to allow paintballs to organize within the carrier. The loader uses the Break
Beam Infrared Sensor in the feed neck to detect shots fired and quickly deliver paintballs to
the marker. The Drive Sensor System makes sure that regardless of the battery voltage, the
loader will feed at the same speed so the user will not see a gradual decrease in performance
as the battery is discharged. The loader will indicate to the user when the battery has been
discharged and needs to be changed. The Empire® Scion™ also uses these systems to detect
a jam in the system (explained below) and to clear the jam efficiently.
ACTIVATING THE LOADER:
Turning On:
Press and hold the Power Button, the LED will turn RED. Release the Power Button when the
LED turns GREEN.
Turning Off:
Press and hold the Power Button until the LED glows RED. Release Power Button, loader is
now OFF.
Low Battery Indication:
If the Battery is low, the LED will blink RED while the loader is idling (not spinning). If the
Battery is OK the LED will blink GREEN.
Auto Anti-jam:
If the loader sees more that 2 consecutive shots fired and does not feed a ball, the loader
will attempt to clear a jam. The loader will try to clear the jam up to 5 times before resuming
normal operation. The LED will turn ORANGE when attempting to clear a jam.
Quick Activate:
If the loader is ON and idle it may be started again by quickly pressing and releasing the Power
Button.
PROGRAMMING:
To Enter Programming Mode:
With the loader OFF, press and hold the Power Button until the LED rapidly alternates RED
and GREEN, then release. The loader will stop on the GREEN light. Release the Power Button
and the loader is now ready to program.
To Exit Programming Mode:
After approximately 5 seconds of inactivity the loader will shut OFF.