Airgo ProCare IC Руководство - Страница 11

Просмотреть онлайн или скачать pdf Руководство для Инвалидное кресло Airgo ProCare IC. Airgo ProCare IC 12 страниц.

Печатать страницу

Frame

Clean and disinfect the chrome parts approximately once a week. For

multipatient use, clean and disinfect as required. Dry the chair as soon as

possible if it is exposed to water or other sources of moisture. Never use an

abrasive cleaner which may scratch your new Airgo ProCare IC wheelchair.

Upholstery

The vinyl upholstery on your Airgo ProCare IC wheelchair is categorized as

a hard surface and should be disinfected at the same time as you clean the

wheelchair's frame. If you notice worn or torn areas, the upholstery should

be replaced immediately as it may not support your body weight and may rip

or tear further and could cause an accident.

REMEMBER: The seat upholstery is the primary source of weight support.

Lubricating

All hinged or moving parts should be kept properly oiled at all times.

A light machine oil is suitable for most of these areas, including footrests,

elevating legrests and wheel locks.

Bearings

Since all bearings are sealed, no cleaning is necessary.

Crossbar

Keep the pivot bolt on the crossbar slightly loose. This will enable all four

wheels to remain on the ground when going over uneven surfaces.

Large wheels

The wheels should be inspected periodically for any sign of wobbling or side

play. To correct any problems, loosen the nut on the axle and then tighten

the axle just enough to straighten it and allow it to turn freely. Retighten the

nut firmly and recheck the wheels.

Tires

Make sure the tires are not worn nor cracked. Worn tires can cause difficulty

in propelling and maneuvering the wheelchair. To ensure proper balance,

both tires should be replaced at the same time. You should clean the tires

occasionally by use of a damp cloth.

Casters

Remove any lint, thread or dirt that may be caught in the casters

to prevent binding.

Handrims

Clean and disinfect approximately once a week at the same time as you

clean the frame. Replace the handrims if there are any signs of rough, sharp

edges or peeling.

Rear wheels locks

You can make minor adjustments to compensate for normal tire wear by

simply loosening the bracket and sliding the assembly forward or backward.

Storage

1. Store your wheelchair in a clean and dry area to prevent corrosion.

2. If stored for more than three months, have your wheelchair inspected by

an Airgo authorized dealer before using.

Required tools

Allen keys: 4 mm and 6 mm

Screw driver: Philips # 2

Socket wrenches: 8 mm, 10 mm, 13 mm, and 17 mm or 1 adjustable wrench