Jandy Jandy Pro Series Руководство по установке и эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Фильтр для плавательного бассейна Jandy Jandy Pro Series. Jandy Jandy Pro Series 20 страниц. Single element cartridge pool & spa cs filters
Также для Jandy Jandy Pro Series: Руководство пользователя (12 страниц), Руководство по установке (16 страниц), Руководство пользователя (20 страниц), Руководство (8 страниц), Краткое руководство по эксплуатации (2 страниц), Руководство по установке и эксплуатации (20 страниц), Инструкции по установке (2 страниц), Руководство по установке и эксплуатации (16 страниц), Руководство по установке и эксплуатации (16 страниц), Руководство по установке и эксплуатации (16 страниц)

Page 4

ENGLISH

To minimize the risk of severe injury or death the filter and/or pump should not be subjected to the piping system

pressurization test.

Local codes may require the pool piping system to be subjected to a pressure test. These requirements are

generally not intended to apply to the pool equipment such as filters or pumps.

Zodiac

pool equipment is pressure tested at the factory.

However, if the WARNING cannot be followed and pressure testing of the piping system must include the filter

and/or pump, BE SURE TO COMPLY WITH THE FOLLOWING SAFETY INSTRUCTIONS:

• Check all clamps, bolts, lids, lock rings and system accessories to ensure they are properly installed and

secured before testing.

• RELEASE ALL AIR in the system before testing.

• Water pressure for test must NOT EXCEED 35 PSI.

• Water temperature for test must NOT EXCEED 100°F (38°C).

• Limit test to 24 hours. After test, visually check system to be sure it is ready for operation.

NOTICE: These parameters apply to Zodiac equipment only. For non-Zodiac equipment, consult equipment

manufacturer.

Chemical spills and fumes can weaken pool/spa equipment. Corrosion can cause filters and other equipment to

fail, resulting in severe injury or property damage. Do not store pool chemicals near your equipment.

Do not start pump dry! Running the pump dry for any length of time will cause severe damage and will void the

warranty.

This pump is for use with permanently installed pools and may also be used with hot tubs and spas if so marked.

Do not use with storable pools. A permanently installed pool is constructed in or on the ground or in a building

such that it cannot be readily disassembled for storage. A storable pool is constructed so that it may be readily

disassembled for storage and reassembled to its original integrity.

Do not install within an outdoor enclosure or beneath the skirt of a hot tub or portable spa. The pump requires

adequate ventilation to maintain air temperature at less than the maximum ambient temperature rating listed on

the motor rating plate.

Jandy

Pro Series VS PlusHP Pumps

WARNING

CAUTION

SAVE THESE INSTRUCTIONS

Installation & Operation Manual