Jandy AquaLink RS All Button Карточка быстрого обзора - Страница 2

Просмотреть онлайн или скачать pdf Карточка быстрого обзора для Контроллер Jandy AquaLink RS All Button. Jandy AquaLink RS All Button 2 страницы.

AquaLink

Basic Programming: To set a particular piece of equipment to turn on and off at a predetermined time, press the MENU button, press

the forward arrow button to scroll to the PROGRAM menu, press ENTER, and then press the button for the equipment that you want to

program. The Controller Display will ask you to enter the day. Use the arrow buttons to select the day and press ENTER. The display will

now ask you for the starting and ending times. Repeat this process for each piece of equipment that you wish to program. You may enter as

many programs as needed for each piece of equipment.

Set the Time: First press the MENU button, then use the forward arrow button to scroll to SET TIME and press ENTER. Scroll to the correct

year,month and day, pressing ENTER for each. Scroll to the correct hour and minute and press ENTER.

Label Auxiliary Functions: Press the MENU button, press the backward arrow button to scroll to SYSTEM SETUP and press ENTER. At

the LABEL AUX menu, press ENTER, and select the AUX button above to label. Scroll to the desired function in the LABEL AUX menu and

press ENTER. Repeat for all functions.

Note 1: The labels "TIMED AUX", "AIR BLOWER" and "FILL LINE" are 30 minute timed cycles.

Note 2: If DIP switches 1,2, or 3 are on, Auxiliaries 1, 2 and 3 are labeled CLEANER, LOW SPEED and SPILLOVER respectively and

cannot be relabeled.

Set the Temperature: Press the MENU button, then use the forward arrow button to scroll to SET TEMP and press ENTER. Use the arrow

buttons to move between pool and spa temperature, then press ENTER. Use the arrow buttons to raise or lower the temperature, then

press ENTER.

Default Temperature

Default Pool Temp. 80°F

Default Spa Temp. 102°F

Default Temp. 1*

80°F

Default Temp. 2*

60°F

*Pool only / Spa only systems

RS All Button Programming & System Defaults

Default Remote Settings

Button 1 - Spa (Filter Pump)*

Button 2 - Spa Heater (Temp 1)*

Button 3 - AUX 1

Button 4 - AUX 2

*Pool/Spa combination systems

Default Freeze Protection Settings

Filter Pump: Freeze Protection ON.

All other Equipment: Freeze Protection OFF

NOTE: If you selected Spa to be freeze protected, water

circulation will switch between pool and spa every 30

minutes during freezing pool and spa every 30 minutes

during freezing conditions once freeze mode is active.