Garden Treasures Living BSH-A-SS Руководство - Страница 11

Просмотреть онлайн или скачать pdf Руководство для Обогреватель патио Garden Treasures Living BSH-A-SS. Garden Treasures Living BSH-A-SS 13 страниц. Gas patio heater

Печатать страницу

OPERATING INSTRUCTIONS

WARNING

FOR YOUR SAFETY

Be careful when attempting to manually

ignite this heater. Holding in the control

knob for more than 10 seconds before

igniting the gas will cause a ball of flame

upon ignition.

When Heater is ON:

Emitter screen will become bright red due to intense heat. The color is more visible at night. Burner

will display tongues of blue and yellow flame. These flames should not be yellow or produce thick

black smoke, indicating an obstruction of airflow through the burners. The flame should be blue with

straight yellow tops. If excessive yellow flame is detected, turn off heater and consult

"Troubleshooting" on page 20.

Re-lighting:

Note: For your safety, control knob cannot be turned OFF without first depressing control knob in

PILOT position and then rotating it to OFF.

1. Turn control knob to OFF.

2. Wait at least 5 minutes, to let gas dissipate, before attempting to relight pilot.

3. Repeat the "Lighting" steps on prior page.

WARNING

FOR YOUR SAFETY

Heater will be hot after use. Handle with

extreme care.

Shut Down:

1. Turn control knob clockwise to PILOT. (Normally, burner will make a slight popping sound when

extinguished.) Burner will extinguish but PILOT will remain ON.

2. To extinguish PILOT, depress control knob and continue to turn it clockwise to OFF.

3. Turn cylinder valve clockwise to OFF and disconnect regulator when heater is not in use.

Note: After use, some discoloration of the emitter screen is normal.

OPERATION CHECKLIST

Perform this check before each use.

Before Operating:

I am familiar with entire owner's manual and understand all precautions noted.

All components are properly assembled, intact and operable.

No alterations have been made.

All gas connections are secure and do not leak.

Wind velocity is below 10 mph.

Unit will operate at reduced efficiency below 40°F.

Heater is outdoors (outside any enclosure).

There is adequate fresh air ventilation.

OPERATING INSTRUCTIONS

Heater is away from gasoline or other flammable liquids or vapors.

Heater is away from windows, air intake openings, sprinklers and other water sources.

Heater is at least 24 in. on top and at least 36 in. on sides from combustible materials.

Heater is on a hard and level surface.

There are no signs of spider or insect nests.

All burner passages are clear.

All air circulation passages are clear.

Children ARE alerted of the hazards of high surface temperatures.

After Operation

1. Gas control is in OFF position.

2. Gas tank valve is OFF.

3. Disconnect gas line.

CARE AND MAINTENANCE

WARNING

FOR YOUR SAFETY:

• Do NOT touch or move heater for at least 45 minutes after use.

• Reflector is hot to the touch.

• Allow reflector to cool before touching.

• Keep exterior surfaces clean.

• Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents.

• While cleaning your unit, be sure to keep the area around the burner and pilot assembly dry at all

times. Do not submerge the control valve assembly. If the gas control is submerged in water, do

NOT use it. It must be replaced.

• Keep the appliance area clear and free from combustible materials, gasoline and other flammable

vapors and liquids.

• Do not obstruct the flow of combustion and ventilation air.

• Keep the ventilation opening(s) of the cylinder enclosure free and clear from debris.

• Air flow must be unobstructed. Keep controls, burner, and circulating air passageways clean.

• Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater

and render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed

air may help clear away smaller particles.

• Carbon deposits may create a fire hazard. Clean dome and burner screen with warm soapy water

if any carbon deposits develop.

Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly than

normal. Frequently check for corroded areas and repair them promptly.

• Use high-quality automobile wax to help maintain the appearance of the heater. Apply to exterior

surfaces from the pole down. Do not apply to emitter screen or domes.