AirGorilla PCO/UV N-Duct Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Очиститель воздуха AirGorilla PCO/UV N-Duct. AirGorilla PCO/UV N-Duct 6 страниц.
Также для AirGorilla PCO/UV N-Duct: Руководство монтажника (8 страниц)

Печатать страницу

REPLACING THE ULTRAVIOLET LAMPS

WARNING

Electrical Shock – Your PCO/UV N-Duct™ system has been installed by your service

company and has been wired or plugged into 110 – 220 VAC electrical power (we suggest

you contact your service company for all service work).

Ultraviolet Light is Harmful – Never look at a lit ultraviolet lamp without UV protective

glasses and skin coverings. Unplug the lamp before servicing.

Ultraviolet Lamp May Cause Injury – Ultraviolet lamps are made of glass and

therefore somewhat fragile. Safety glasses and gloves should be worn when handling a

UV lamp. In addition, UV lamps can be very hot and cause skin burns. Allow lamp to cool

before handling.

Steps for Replacing the Ultraviolet Lamps:

1. READ THE WARNINGS ABOVE.

2. If the unit is plugged into an AC outlet, simply unplug it before servicing the UV

3. Open the Display Panel door. The Display Panel door is connected to a kill switch that

disables power inside the unit when the door is opened.

4. The unit contains 2 UV lamps. The base of the UV lamps (white in color) are visible on the left

side of the enclosure. Attached to each lamp base is a white socket with wires leading to the

power supplies that are housed to the right (separately enclosed). Pull the lamp socket off the

UV lamp base.

5. Each lamp base is held in a cavity by two swivel clamps. Simply swivel them out of the way.

Grab the lamp base and pull it toward you gently. The lamps are held snug so a little force

may be necessary to pull them out. The lamps are 16" long.

6. Install new, replacement lamps (AirGorilla #DR36-1).

a. Make sure lamp is clean – use alcohol wipe to remove dirt and fingerprints.

b. Insert UV lamp into cavity.

c. Turn swivel clamps over lamp base to hold secure.

d. Attach lamp socket (align holes in socket to lamp base pins).

7. Push the " Reset" button next to the lamp (there is a reset button for each lamp) that restarts

the 9000 hour timer.

8. Close the Display Panel door. Plug in the power cord if applicable. Within a few seconds, the

LED lights that indicate POWER ON and AIR PURIFYING should be lit (not the REPLACE LAMP

LED).

If the correct LEDs are not lit, reopen the Display Panel door and make sure the lamp socket

is attached fully to the lamp base pins, then make sure the Display Panel door is closed

completely. If the LED lights are still not lit, contact the service company that originally

installed the unit.

When a UV lamp has passed its useful life (9000 hrs.) or has burned out prematurely, an audible

" beep" alert can be heard. If you wish to stop the beep sound before you replace the UV lamp,

push the reset button next to the lamp (do not forget to push the reset button again once a new

lamp is installed), or open the Display Panel door which disables power inside the unit.

lamps.