Gardena 19065-68 Краткое руководство - Страница 3
Просмотреть онлайн или скачать pdf Краткое руководство для Газонокосилка Gardena 19065-68. Gardena 19065-68 4 страницы.
Печатать страницу3. Connecting the boundary wire
See chapter 3.5 in the Operator's Manual
1. Open the connector and lay the wire ends in the recesses on each connector.
2. Press the connectors together using a pair of pliers.
3. Cut off any surplus boundary wire. Cut 1 to 2 cm above the connectors.
4. Press the connectors onto the contact pins, marked AL (left) and AR (right) , on the
charging station. It is important that the right-hand wire is connected to the right-hand
contact pin, and the left-hand wire to the left-hand pin.
5. Mark the wires with the accompanying cable markers. This makes it easier to reconnect
the wires correctly.
4. Placement of and connecting the guide
wire
See chapter 3.6 in the Operator's Manual
1. Place the guide wire under the charging station, using any of the two guide
channel positions marked with "GUIDE".
2. Fit the connector to the guide wire in the same way as for the boundary wire,
according to the instructions above.
3. Fasten the connector to the contact pin marked G1 (guide) on the charging station.
4. Lay the guide wire at least 2 metres straight out from the front edge of the
charging station.
5. Run the guide wire to the point on the boundary loop where the connection will be
made. Avoid laying the wire at tight angles.
6. Cut the boundary wire with a wire cutters at the centre of the eyelet that was made
in point 2.3.
7. Connect the guide wire to the boundary wire using the accompanying couplers.
Press the couplers completely together with a pair of pliers.
„As a complement to this Quick Guide, there are step by step
installation movies available on the GARDENA website,
www.gardena.com."
Power supply
Low voltage cable
Boundary wire and
couplers
1
2
4
5
1
7
Pegs
3
1
4
min 2 m / 7 ft
Connectors
Measurement
gauge