Lexmark C935 Series Краткая справка

Просмотреть онлайн или скачать pdf Краткая справка для Принтер Lexmark C935 Series. Lexmark C935 Series 10 страниц. Hard disk and non-volatile memory guide
Также для Lexmark C935 Series: Брошюра (5 страниц), Руководство по подключению (6 страниц), Настройка (2 страниц), Руководство по печати (4 страниц), Руководство для СМИ (3 страниц), Руководство по качеству окраски (7 страниц), Руководство по устранению заторов (7 страниц), Руководство по устранению неполадок (11 страниц), Руководство по снабжению (2 страниц), Информация (9 страниц)

Печатать страницу
Lexmark C935 Series Краткая справка
Lexmark™ C935
Quick Reference
Loading paper and

specialty media

Loading the 520-sheet trays
The printer has a standard 520-sheet tray (Tray 1), and it may have
one or more optional 520-sheet trays. All 520-sheet trays support
the same paper sizes and types. Paper may be loaded in the trays
in either the long-edge or short-edge orientation.
1
Grasp the handle, and pull the tray out.
2
Squeeze the width guide tabs together as shown, and move
the width guide to the correct position for the paper size being
loaded.
3
Squeeze the length guide tab inward as shown, and slide the
guide to the correct position for the paper size being loaded.
Note: Use the size indicators on the bottom of the tray to help
position the guides.
1
4
Flex the sheets back and forth to loosen them, and then fan
them. Do not fold or crease the paper. Straighten the edges on
a level surface.
5
Load the paper stack with the recommended print side faceup.
Load the paper in either the long-edge or short-edge
orientation as shown below:
Notes:
•
Load sizes larger than A4 in the short-edge orientation.
•
Paper must be loaded in the short-edge orientation to
create booklets if the optional booklet finisher is installed.
6
Make sure the paper guides are secure against the edges of
the paper.
7
Align the tray, and insert it.
8
If a different type of paper was loaded than the type previously
loaded in the tray, change the Paper Type setting for the tray
from the control panel.