Gardena smart SILENO city Краткое руководство - Страница 2
Просмотреть онлайн или скачать pdf Краткое руководство для Газонокосилка Gardena smart SILENO city. Gardena smart SILENO city 4 страницы.
Также для Gardena smart SILENO city: Краткое руководство (4 страниц), Краткое руководство (4 страниц)
Печатать страницу
GETTING STARTED WITH
THE GARDENA ROBOTIC LAWN MOWER
For more information and instructions, please read the complete supplied Operator's manual or visit www.gardena.com.
Installation support videos can be found on www.gardena.com.
1. To install the charging station
1. Place the charging station on a flat level surface where there is open space.
NOTE: To place the charging station in a limited space, under a veranda or in a
corner, please read the Operator's manual.
2. Connect the low voltage cable to the charging station and the power supply.
3. If outdoor, put the power supply at a minimum height of 30 cm / 12 in from the
ground.
4. Connect the power supply to a 100-240 V wall socket.
5. Place the robotic lawn mower in the charging station.
6. Push the ON/OFF button to switch on the robotic lawn mower and to charge the
battery while the boundary wire is laid.
NOTE: Do not continue with any product settings before the installation is complete.
2. To install the boundary wire
1. Lay the boundary wire so that it forms a loop around the
whole work area using stakes supplied or bury the wire.
NOTE: Do not lay the boundary wire in sharp bends.
2. Adapt the distance between the boundary wire and different
objects.
A: Lay the boundary wire around all work area in a loop.
B: High obstacles > 5 cm / 2 in e.g. wall or fence.
C: Low obstacles 1-5 cm / 0.4-2 in. or a dropped edge e.g. flower bed.
D: Objects level with the lawn 0-1 cm / 0.4 in e.g. path, paving stones.
E: Make an island to isolate areas.
3. Make an eyelet at the point on the boundary wire where the
guide wire is later connected (F).
4. To handle slopes, passages and secondary areas, refer to
the Operator's manual.
1. STOP button
2. LED for function check of the charging station,
boundary and guide wires
3. Charging station
4. Display
5. Keypad
6. ON/OFF button
7. Start button
P01_P02_QG_EN.indd 2
10 cm / 4"
F
30 cm / 12
"
C
A
1
3
3
2
0 cm / 0"
E
3
2
1
2
6
1
10 cm / 4"
D
35 cm / 14"
B
4
7
5
2019-10-29 12:55:25