KitchenAid Oven Руководство по установке - Страница 2
Просмотреть онлайн или скачать pdf Руководство по установке для Печь KitchenAid Oven. KitchenAid Oven 13 страниц. Electric built-in 24” and 27” thermal single and double ovens 24” and 27” thermal convection single and double ovens
Также для KitchenAid Oven: Инструкция по установке (7 страниц)
Печатать страницуBefore you start...
Your safety and the safety of
others are very important.
We have provided many important
safety messages in this manual and
on your appliance. Always read and
obey all safety messages.
This is the safety alert
symbol.
This symbol alerts you to
potential hazards that can kill or hurt
you and others.
All safety messages will follow the
safety alert symbol and either the
word "DANGER" or "WARNING".
These words mean:
DANGER
You can be killed or seriously
injured if you don't immediately
follow instructions.
WARNING
You can be killed or seriously
injured if you don't follow
instructions.
All safety messages will tell you
what the potential hazard is, tell you
how to reduce the chance of injury,
and tell you what can happen if the
instructions are not followed.
Tools needed for installation:
Phillips
screwdriver
2
Important: Observe all governing
codes and ordinances.
Proper installation is your responsibility.
Have a qualified technician install this
oven.
Oven location should be away from
strong draft areas, such as windows,
doors and strong heating vents.
Cabinet opening dimensions that are
shown must be used. Given dimensions
provide minimum clearance.
Recessed installation area must provide
complete enclosure around the recessed
portion of the oven.
Electrical ground is required. See
"Electrical requirements."
Electrical supply outlet should be
located in the rear wall on the lower right
side of the cutout or in an adjacent
cabinet. The outlet must be recessed. If
the electrical outlet is located in an
adjacent cabinet, provide a 1-3/8" dia.
minimum power supply cord plug
clearance hole in the back of the cutout or
support surface.
Oven support surface MUST be solid,
level and flush with bottom of cabinet
cutout.
There is no provision to level the oven
after it has been installed. If the
installation is not level, the door may
slide open or not seal tightly allowing
heat to escape resulting in poor oven
performance.
It is the customer's responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is
adequate and in conformance with
National Electrical Code, ANSI/NFPA 70
— latest edition*, or CSA Standards
C22.1-94, Canadian Electrical Code, Part 1
and C22 No. 0-M91 — latest edition** and
all local codes and ordinances.
Copies of the standards listed may be obtained
from:
* National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02269
** Canadian Electrical Association
178 Rexdale Boulevard
Etobicoke (Toronto), Ontario M9W 1R3
Parts supplied:
2 screws