Gardena 1422 Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Водяной насос Gardena 1422. Gardena 1422 16 страниц. Garden pump
Печатать страницу
5. Maintenance
Cleaning your Garden Pump:
6. Trouble Shooting
Free the
impeller:
Cleaning the pump thoroughly: 1. For art.1429/1432: Unscrew 2
12
4. Open all possible shut-off devices in the pressure line
(watering accessories, Water Stop, etc.).
5. Drain remaining water
pe during the suction process.
6. Set On/Off switch
7. Plug the pump into a 230 V / 50 Hz alternating current socket.
8. Set On/Off switch
9. Hold the pressure hose
pump until the pump begins to pump.
If the pump does not deliver liquid after 7 minutes, set the
On/Off switch
The specified maximum self-priming height (see 9. Technical
Data) is only achieved if the pump is filled via the filler neck until it
overflows and if the suction hose is held as high as possible while
filling and during the self-priming procedure so that no liquid can
escape from the pump via the suction hose.
The GARDENA Garden Pump is essentially maintenance-free.
The pump must be cleaned after pumping chlorinated swimming
pool water.
1. Rinse the Garden Pump with lukewarm water (max. 35 °C).
If necessary add some soft cleaning agent (e.g. washing-up
liquid).
2. Remove residuals according to the waste disposal laws
applicable in your area.
Warning ! Electric shock !
Risk of injury due to electric shock.
Disconnect Garden Pump from the mains before
trouble-shooting
An impeller blocked by dirt can be freed again.
Turn the impeller bolt
This will free the blocked impeller.
screws
, remove handle
unscrew 10 screws
remove the side components
2. Unscrew the 6 housing screws
, remove housing cover
and clean the impeller chamber.
3. Tighten the impeller bolt
using a screwdriver.
4. Loosen the impeller
5. Install the impeller
in pressure hose so that air can esca-
to position „0" position.
to position „1" position.
approx. 1 m vertically above the
to position „0" (see 6. Trouble-Shooting).
using a screwdriver.
,
and
.
using a ring spanner, remove and clean.
in the reverse order.