Gardena 4000/5 Inox Руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Водяной насос Gardena 4000/5 Inox. Gardena 4000/5 Inox 8 страниц. Submersible pressure pump

Печатать страницу

Thermal motor protector

3. Initial Operation

Connecting the hose :

Tie the fastening rope

to the pump :

4. Operation

When connecting the pump to the water supply system,

the country-specific sanitary regulations must be observed

to prevent water not of drinking water quality being drawn

back in.

➔ If necessary, contact your sanitary expert.

The pump is automatically switched off on overheating by

the built-in thermal motor protector. After having cooled down,

the motor automatically switches on again (see 6. Trouble-

Shooting).

The pump fitting is equipped with a 33,3 mm (G 1") thread to

which 13 mm (1/ 2 "), 19 mm (3 /4 ") and 15 mm (5 /8 ") hoses can

be connected by using GARDENA hose connection system

fittings.

1. Screw the pump fitting

tighten it manually until the washer fits closely.

2. Attach the hose to the pump fitting

Best results in delivery capacity of the pump are achieved

when using 19 mm (3 /4 ") hoses in conjunction with GARDENA

"Profi" Maxi-Flow System fittings (e.g. Art. No. 1752) or

25 mm (1") hoses with fittings available at your sanitary dealer.

When connecting simultaneously several hoses / accessories, we

recommend to use either our GARDENA Twin-Tap Connector

or our Four Channel Water Distributor (Art. No. 1210 / 1194)

which can be directly screwed onto the pump fitting

v Fasten the fastening rope

To ensure that the pump draws the water out, the water to be

drained must be at least 20 cm deep.

1. Submerge the pump in the well or other water reservoirs,

using the fastening rope

In order to avoid contaminations, the pump should not be

placed directly on the ground. It must hang freely min. 30 cm

above ground.

2. Secure the fastening rope

3. When using the pump in deep wells or shafts (ot more than

approx. 5 m), the power cable

of clamps alongside the fastening rope

4. Plug the power cable

onto the outlet of the pump and

to the loop

for fastening rope.

is to be guided by means

into a mains socket.