Broadata LBO-H/DP-EAD-T Руководство - Страница 6

Просмотреть онлайн или скачать pdf Руководство для Передатчик Broadata LBO-H/DP-EAD-T. Broadata LBO-H/DP-EAD-T 18 страниц. Link bridge fiber optic hdmi/displayport transmitter system

Печатать страницу

2.0 SETUP

The BCI LBO Optcial Extender Series units are used in pairs. One

LBO-H/DP-EAD-T transmitter unit is located at the near-end (source)

and connected through a single fiber optic cable, to one of the LBO

receivers like the LBO-HDMI-R receiver shown below and located at

the far-end (sink) of the link. Figure 2-1 depicts a typical installation for

the LBO-H/DP-T-EAD and LBO-HDMI-R.

LBO-H/DP-T with LBO-HDMI-R

2.1 Mounting

Before installing the units into your housing, make sure there is

enough space to pull and connect both the electrical and optical

cables without stressing them beyond the manufacturer's

limitations (also known as the minimum bend radius).

2.2 Cabling and Connectors

In order to setup the LBO-H/DP-EAD-T properly, make sure to

observe the following instructions when installing the proper

cables. The LBO-H/DP-EAD-T requires two parts to the cabling

setup, the electrical and the optical.

Broadata Technical Support, [email protected]

LBO-H/DP-EAD-T User Manual

Link Bridge

Fiber Optic HDMI/DisplayPort Transmitter

Figure 2-1