Gardena HighCut 48-Li 8882 Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Триммер Gardena HighCut 48-Li 8882. Gardena HighCut 48-Li 8882 15 страниц.
Печатать страницу
The charging cable should be checked regularly for
signs of damage or ageing (brittleness) and may only
be used if it is in perfect condition.
The charger unit provided may only be used to charge
the rechargeable batteries supplied with the Hedge
Trimmer.
Non-rechargeable batteries must not be charged with
this battery charger (danger of fire).
The Hedge Trimmer must not be operated during
charging.
3. Assembly
Fitting the hand guard :
1
5
2
4. Initial Operation
Charging the battery :
16
Before the hand guard
fitted, the position of the hedge
trimmer has to be changed – from
the packing position A to the
working position C.
A Hold down the button
the swivel head
(see 5. Operation "Tilting the
swivel head" ).
B Hold down the button
rotate the cutting unit
3
0° position (see 5. Operation
4
"Rotating the cutting unit by 90°" ).
C Hold down the button
the swivel head
v Push the hand guard
swivel head
fittings engage.
WARNING !
Overvoltage damages batteries and the battery
A
charger.
V Ensure the correct mains voltage.
Before using for the first time, the battery must be fully charged.
Charging time (for uncharged battery) see 10. Technical Data.
The lithium-ion battery can be charged in any state of charge,
and the charging process can be interrupted at any time without
harming the battery (no memory effect).
In order that the fully charged battery does not self-discharge
via the charger, it should be disconnected from the charger after
charging.
After charging, disconnect the charger from the mains.
Only charge battery between 10 – 45 °C. After heavy
duty service allow battery to cool down first.
Storage :
The trimmer must not be stored over 35 °C or under
direct exposure to sunlight.
Do not store the Hedge Trimmer in places with static
electricity.
5
can be
1
and tilt
2
by 90°
3
and
4
to the
1
and tilt
2
to 0°.
5
onto the
2
until the snap-on
A
B
C