Gardena HS 36 Руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Триммер Gardena HS 36. Gardena HS 36 12 страниц. Accu hedge trimmer
Также для Gardena HS 36: Руководство по эксплуатации (9 страниц)
Печатать страницу
Cleaning the mower :
8. Troubleshooting / Service
Problem
Abnormal noise,
Clattering in the mower
Motor will not start
Motor jams and is noisy
Motor turns off
Runs unevenly, mower
vibrates significantly
16
Deposits affect the cutting result as well as discharge of grass clip-
pings. Residual dirt and grass is easily removed immediately after
mowing.
1. Remove grass deposits with a brush and a cloth.
2. Oil the red cutting mechanism lightly with thin oil (e.g. sprayed
oil).
DANGER ! Cutting tool can cause injuries !
V Before rectifying faults, wait for the cutting tool to
stop, wear suitable work gloves and pull out the
mains plug.
Possible cause
Screws / components loose.
Foreign bodies on the blade.
Notch in the blade.
Blades are striking each other
too hard.
Power cable faulty.
Fuse / fault current
circuit-breaker has
responded.
Extension cable may not have a
large enough cross-section.
Circuit breaker has been
triggered.
Blocked by foreign body.
Blocking protection activated.
Cutting load too high.
The cutting height you have
selected is too low;
Circuit breaker has been
activated.
Cutting tool damaged.
Blade very dirty.
Remedy
v Tighten screws or send
to GARDENA Service.
v Remove foreign bodies.
v Remove notches with
grindstone.
v Adjust cutting mechanism.
v Unplug from mains and
check power cable.
Check power cable and
replace fuse / switch fault
current circuit breaker
on again.
v Use extension cable with
cross-section complying with
table (2. Safety references).
v Wait approx. 5 -10 minutes
then turn on the mower
again.
1. Release starting handle.
2. Unplug mains plug
at the socket.
3. Remove foreign body.
v Reduce mowing speed and /
or raise cutting height.
Let the motor cool for 5 -10 min-
utes, then use the mower with
a higher cutting height and
reduce the cutting height and
the mowing speed in stages.
v Have cutting tool checked
by an authorised specialist
dealer or GARDENA-
Service.
v Clean blade.