KitchenAid CMO-2743 Руководство по установке - Страница 4
Просмотреть онлайн или скачать pdf Руководство по установке для Микроволновая печь KitchenAid CMO-2743. KitchenAid CMO-2743 6 страниц. Electric built-in microwave/single oven
Печатать страницу
MOBILE HOME INSTALLATION
When installed in a mobile home, the installation must conform to the Manufactured
Home Construction
and Safely
Standards, Title 24 CFR, Part 3280 (formerly Ihe Federal Standard for Mobile Home Construction
and Safety, Title
24, HUD, Part 280).
Four-wire power supply must be used and the appliance wiring must be revised. See Electrical Requirements.
Copies of the standards listed may be obtained from:
'Natlonal Fire Protect!on Assoclatlon
Batterymarch Park
Quincy, Massachusetts
02269
UNPACKING THE UNIT
Personal
Injury Hazard
More than one person
is required
to lift or move
the oven because
of Its welght
and size.
Failure to follow these Instructions
may result In
personal
Injury.
The oven should ~YZ left on the carton base until it is ready to put into the
cabinet. It is also recommended that the pads over the door(s) be left in
place. These precautions will reduce the possibility of damage lo the front
of the unit and the bottom of the front frame.
Prlsr to installation,
check the electrical service to assure that
it
agrees
with the specifications
on the oven serial plate
To Remove
Oven
Rackr
Remove all cords, tape, and wire used to hold various parts In position dur-
Slide
rack
forward
until
bar on back
of rack
ing shipment. Study all labels and tags and remove those on an exposed
touches
first
stop
surface after installation, unless instructed to leave them for the owner.
Clft
front
of rack
until
rear
portIon
of rack
Remove oven racks from the Inside of the oven and unwrap. Put
slides
out between
front
two stops
to one side while the oven
IS
being installed in cabinet. Take broiler pan, grid, and any other accessories from the pack-
ing on top of the oven and keep them with literature packet In a locatlon where they will
be retained
for use by the owner.
ELECTRICAL CONNEflION
Electrical
Shock Hazard
Disconnect power supply before making any electrical connections.
Failure to do so may result in electrical shock.
Connect
the conduit
from the oven to the junction box and properly connect to the power supply leads The unit
IS
now
ready to install In cabinet
GROUNDING
-
THE OVEN MUST
BE GROUNDED
Do not work on the oven wiring until the oven has been positively
grounded
The oven frame IS grounded
through
the bare grounding
wire
Connect
the white neutral to the service
neutral
wire
at the junction
box.