Makita 6073DW Руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сверло Makita 6073DW. Makita 6073DW 16 страниц. Equipped with electric brake 10 mm (3/8”) with fast charger
Печатать страницу14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to
see that keys and adjusting wrenches are removed from tool before turning
it on.
15. AVOID UNINTENTIONAL STARTING. Don't carry plugged-in tool with finger
on switch. Be sure switch
is
OFF when plugging in.
16. OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, u s e only
extension cords intended for u s e outdoors and
so
marked.
17. STAY ALERT. Watch what you
are
doing, u s e common sense. Don't operate
tool when you are tired.
18. CHECK DAMAGED PARTS. Before further u s e of the tool, a guard
or
other
part that is damaged should be carefully checked t o determine that it will
operate properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting, and any
other conditions that may affect its operation. A guard or other part that
is damaged should be properly repaired or replaced by an authorized serv-
ice center unless otherwise indicated elsewhere in this instruction manual.
Have defective switches replaced by authorized service center. Don't use
tool if switch d o e s not turn it on and off.
19.
GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded
surfaces. For example; pipes, radiators, ranges, refrigerator enclosures.
20. REPLACEMENT PARTS. When servicing, u s e only identical replacement parts.
VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle,
outlet,
etc.J
be sure the voltage supplied is the same a s that specified on the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY t o the user - as well a s damage t o
the tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with
voltage
less
than the nameplate rating is harmful t o the motor.
3