Makita 6222DWE Руководство по эксплуатации - Страница 10

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сверло Makita 6222DWE. Makita 6222DWE 16 страниц. Cordless driver drill equipped with electric brake

Печатать страницу

Drilling operation

First, turn the adjusting ring so that the pointer on the adjusting ring points to the

-.-

mark-

ing. Then proceed as follows.

*Drilling in wood

When drilling in wood, best results are obtained with wood drills equipped with a guide

screw. The guide screw makes drilling easier by pulling the bit into the workpiece.

To prevent the bit from slipping when starting a hole, make an indentation with a center-

punch and hammer at the point to be drilled. Place the point of the bit in the indentation

and start drilling.

Use a cutting lubricant when drilling metals. The exceptions are iron and brass which

should be drilled dry.

*Drilling in metal

CAUTION:

*Pressing excessively on the tool will not speed up the drilling. In fact, this excessive pres-

sure will only serve to damage the tip of your bit, decrease the tool performance and

shorten the service life of the tool.

*There is a tremendous force exerted on the tool/bit at the time of hole breakthrough. Hold

the tool firmly and exert care when the bit begins to break through the workpiece.

*A stuck bit can be removed simply by setting the reversing switch to reverse rotation in

order to back out. However, the tool may back out abruptly if you do not hold it firmly.

*Always secure small workpieces in a vise or similar hold-down device.