Makita 6300D Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сверло Makita 6300D. Makita 6300D 15 страниц. 13 mm (1/2") equipped with electric brake
Charging
Use the Fast Charger DC1000 to charge the
Battery Cartridge 1000.
To remove the battery cartridge, push up
the slide plate and grasp the cartridge care-
fully while withdrawing it from the tool.
Plug the fast charger into your power
source. Insert the battery cartridge
so
that the plus and minus terminals on the
battery cartridge are on the same sides
as their respective markings on the fast
charger. Insert the cartridge fully into the
port so that it rests on the charger port
floor. Check to
see
that the charging light
comes on. When
it
goes out, you may re-
move the fully charged battery cartridge.
After charging, unplug the charger from
the power source.
To insert the battery cartridge, slide i t all the way inside the tool. Then pull down the
slide plate to secure the battery cartridge.
CAUTION
:
0
Your new battery cartridge is not charged. You will need to charge i t before use.
0
If
you
try to charge
a
cartridge from
a
just-operated tool, sometimes the charging light
will not come on. If this occurs,
let
the cartridge
cool
off for
a
while. Then re-insert i t
and try to charge
it
once more.
When
you
charge a new battery cartridge or
a
battery cartridge which has not been used
for
a
long period, it may not accept
a
full charge. This i s a normal condition and does
not indicate
a
problem. You can recharge the battery cartridge
fully
after discharging
it
almost completely a couple of times.
0
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
6