Gardena ErgoJet 3000 Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Воздуходувка Gardena ErgoJet 3000. Gardena ErgoJet 3000 18 страниц. Electric blower/vac
Также для Gardena ErgoJet 3000: Руководство (10 страниц), Руководство по эксплуатации (19 страниц), Руководство по эксплуатации (19 страниц), Руководство по эксплуатации (17 страниц), Руководство по эксплуатации (10 страниц), Руководство по эксплуатации (8 страниц)

3. Assembly

WARNING:

inlet cover or attempting to install or remove the blower tube or vacuum tubes.

The motor must be stopped and the impeller blades no longer turning to avoid

serious injury from the rotating blades.

Fitting the blower tube:

Fitting the vacuum tubes:

Stop the unit and unplug the extension cord before opening the

1. Align the grooves on the blower tube

blower outlet

2. Push the blower tube onto the blower outlet until it snaps into

place; tube is secured to blower by tube release button

3. To remove the blower tube, press the tube release button

while pulling on tube.

NOTE: A safety switch will prevent the unit from starting if the

blower tube is not installed correctly.

1. Open the inlet cover

and pulling up on the vacuum assist handle

2. Allow latch to snap into rear handle of blower

Ensure mains cable

NOTE: There are 2 vacuum tubes, an upper tube

tube

The upper tube has a hinge and hooks on one end and is cut

straight on both ends. The upper tube attaches to the blower unit.

The lower tube has a curved end that you point toward the ground

during vacuum use. The lower tube attaches to the upper tube.

3. To attach the lower vacuum tube

tube

, first align the seams of the two tubes.

Then, press the two tubes together until the lower tube is

fully seated in the upper tube.

by releasing the latch

remains free.

with the grooves on the

as shown

and a lower

to the upper vacuum