AEG B3007H-B Руководство пользователя - Страница 31

Просмотреть онлайн или скачать pdf Руководство пользователя для Печь AEG B3007H-B. AEG B3007H-B 39 страниц. 30” built-in oven

Preparing the oven cavity

WARNING:

It is important to the performance of the oven and the protection of adjoining cabinets that

the following installation preparation is observed.

1. The oven cavity floor should accommodate an opening to allow a satisfactory flow

of air to circulate around the appliance.

2. If possible the rear wall of the oven cavity should also have an opening – it should

be clear to allow for improved air circulation around the appliance.

The above steps will greatly reduce the outer oven surface temperatures making the

kitchen environment safer. It will also protect both the appliance and the adjoining

cabinets.

If the oven is mounted in a tall or demi-tall cabinet, there must be a minimum gap of 1

cut out of the shelf and behind the upper cabinet to allow air to flow freely.

A void must be cut out in the shelf of the cabinet. Leave 4" of shelf material around the void.

When installing a double oven additional support must be added to the shelf with the void. The

support must be able to withstand a minimum weight of 245 lbs (111kg) for the 24" double oven

and 265lbs (120kg) for the 30" double oven.

If insufficient airflow is provided, the life of the appliance will be shortened.

NOTE: Install false backs for storage spaces. This will prevent contents from falling through the

vent space. In addition, warm air will not interfere with your stored contents.

Once correctly wired into (while electrically isolated from) the main power, place the oven into the

recess and ensure the appliance is parallel to the front fascia of the enclosure, use packing under

the appliance if necessary. Four screws are supplied to secure the oven to the cupboard cavity.

The fixing holes are in the oven trim surrounds (visible when you open the oven door/s). Slide the

oven fully into the recess and insert the four screws through the mounting holes and into the

cupboard surround to secure the oven position. We recommend a flush to cupboard face

installation. The measurement of the front trim of the oven (20mm) is designed to equal normal

cupboard facing material after allowing for the body of the oven to be secured against the

cupboard frame.

" (4cm)