Alinco DR-510T Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Трансивер Alinco DR-510T. Alinco DR-510T 16 страниц. Vhf/uhf dual band fm transceiver
Также для Alinco DR-510T: Руководство по эксплуатации (8 страниц)
Печатать страницуO MHz key
The MHz key is used to change the
frequency up or down in one MHz
Steps.
Press the MHz key, and the decimal
point and kHz digits will disappear
from the display. The frequency in
MHz will be changed by rotating the
main dial or pressing the UP/DOWN
buttons on the microphone. Press
the MHz key again or the PTT
Switch to retum the display to the
complete frequency readout.
BAND is used with the F key to
select VHP or UHF band. See
page 8.
o VFO/M (VFO/MEMORY)
key
VFO/M is used to select VFO or
Memory mode.
Press the VFO/M key to alternate
between VFO and the Memory
Channel mode.
CH.SP is used with the F key to
select frequency steps for program-
ming and scanning. See page 8.
(D REV (Reverse) key
REV is used to invert the TX and RX
frequency in Repeater mode.
LOCK is used with the F key to
disable the Function keys. See
page 8.
(DSHIFTkey
The SHIFT key is used to select the
desired transmitter offset during re
peater or Cross Band Operation.
When the key is pressed, the offset
mode cycles from - to -h to Dual to
Simplex.
(D TONE key
(DR-510E: CTCSSkey)
The TONE key is used to:
A. Activate the Tone frequency
selection process. See page 12.
B. Enable/Disable
the
Encode/
Decode functions. See page 12.
The BEEP key is used with the F
key to Enable/Disable the function
confirmation tone. See page 8.
(E) PRI (Priority) key
The PRI key is used to control
Priority function. See pages 11-12.
(D SCAN key
The SCAN key is used to activate
the frequency scan and memory
Scan functions. See pages 10-11.
The SKIP key is used with the F key
to skip busy memory frequencies
when scanning. See page 8.
(DCALLkey
(DR-51OE: Tone Burst key)
The CALL key is used to bring
Memory Channel "C" to the display.
See page 9.
The CALL W is used to enter
a frequency into memory Channel
"C". See page 9.
0 Microphone Connector
Plug the microphone into this jack.
DC5V
NC(|>
@UP
<DDWN
GND (MIC)
®GND
- 5 -