Brother 884-B02 Руководство по эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Швейная машина Brother 884-B02. Brother 884-B02 38 страниц. Compact overlock machine

Печатать страницу

Brother 884-B02 Руководство по эксплуатации

Powering the machine

Turning on the machine

1. Insert the three-pin plug into the socket on the

bottom right side of the machine. Insert the

power supply plug into a power outlet.

2. Turn the main power and light switch <A> to "I"

mark (to "O" mark to turn off).

<A>

Operation

When the foot controller is pressed lightly, the

machine runs at a low speed. As the foot controller

is pressed further, the machine will increase

speed. When the foot controller is released, the

machine stops.

NOTE (For U.S.A. only):

Foot controller: Model KD-1902

This foot controller can be used on the machine

with product code 884-B02 and 884-B03.

* The product code is shown on the machine rating

plate.

Turning direction of hand wheel

The hand wheel <A> turns in a counterclockwise

direction (direction of arrow). This is the same

direction as an ordinary home sewing machine.

The needles move to their highest positions by

turning the hand wheel so that the mark <B>

on the hand wheel is aligned to the line on the

machine.

<B>

<A>

Opening/ Closing front cover

It is necessary to open the front cover when

threading this machine. Slide it to the right 1 and

open 2, or close it and slide it to the left.

CAUTION

For your safety, make sure that the front cover is

closed when operating the machine.

Always turn off the machine before opening the

front cover.

Attaching/ Removing presser foot

1. Turn off the main power and light switch or

disconnect the electric supply plug.

2. Raise the presser foot lever. 1

3. Turn the hand wheel 2 so that the mark on

the hand wheel is aligned to the line on the

machine. (See CHAPTER1 "Turning direction

of hand wheel".)

4. Push the button on the presser foot holder and

the standard presser foot will be released. 3 4

5. Raise the presser foot farther by pushing the

presser foot lever upward. Then remove the

presser foot and store it in a safe location.

6. Again, raise the presser foot farther by pushing

the presser foot lever upward. Then place the

presser foot just under the presser foot holder

<A> so that the groove in the bottom of the

presser foot holder <B> is aligned and catches

the bar on the top of the foot <C>. Then lower

the presser foot lever to attatch the foot,

pushing the button on the presser foot.

<A>

<B>

<C>