Brother 885-X03 Руководство по эксплуатации - Страница 35

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Step

Step 3

(Back bar tack)

1. Turn the pattern selection dial to "c" (same

position as in step 1).

2. Sew 5 to 6 stitches.

3. Stop the machine when the needle is at the right

side of the stitch and then raise the needle from the

material.

Step 4

(Right side)

1. Set the pattern selection dial to "d".

2. Sew the right side until the needle reaches the

stitches sewn in step 1.

■ Securing the Stitching and Cutting the

Buttonhole

To secure the stitching, turn the material

1

90 degrees counterclockwise and sew

straight stitches to the end of the front bar

tack of the buttonhole.

Remove the material from the machine.

2

We recommend that you put pins across

both ends of the buttonhole to prevent the

stitches from being cut.

Cut an opening in the middle of the

3

buttonhole with the seam ripper tool. Be

careful not to cut through any stitches.

CAUTION

●

When using the seam ripper to open the

buttonhole, do not put your hand or

finger in the path of the ripper. The seam

ripper may slip and you may be injured.

Sewn section

Pattern

If the stitching on the two sides of the buttonhole is not

the same, you can make the following adjustments.

Set the stitch length dial between "F" and

1

"1.5" and sew the buttonhole on a scrap

piece of fabric to observe how the

material is fed.

If the right side of the buttonhole is too

2

open or tight, adjust the feeding of the

material with the stitch length dial.

1

2

1 Right side

2 Shorter

3 Longer

After obtaining a satisfactory feed on the

3

right side, stitch the buttonhole and

observe the feeding.

If the left side is too open or tight

4

compared with the right side, adjust the

buttonhole fine-adjustment screw as

described in the following paragraphs.

1

3

1 Buttonhole fine-adjustment screw

2 Left side

3 Buttonhole appearance

3

2

3

34

4