Garmin MSC 10 Руководство по установке - Страница 4

Просмотреть онлайн или скачать pdf Руководство по установке для Морская система GPS Garmin MSC 10. Garmin MSC 10 14 страниц. Marine satellite compass

Surface Mounting the Compass

Before you mount the compass, you must review the mounting location considerations and select a mounting

location.

NOTE: The supplied M4 x .07 x 45 threaded rods can be used on mounting thicknesses of 5 to 30 mm (

in.) (recommended). For surfaces over 30 mm (1

included).

1 Secure the included mounting template to the selected mounting location.

2 Drill the three 5 mm (

3 Drill the 25 mm (1 in.) cable hole in the center.

4 Install the included gasket

5 Route the cable

through the center hole, and connect it to the compass.

6 Insert the three threaded rods

Up to 35 mm (1

in.) of the threaded rods may extend below the compass.

7 Place the compass on the surface, feeding the threaded rods through the holes you drilled previously.

8 Apply a bead of marine sealant on the mounting surface around each mounting hole.

9 Fasten the compass

washers

, and hex nuts

10 Using a torque wrench, tighten the nuts to 13.7 to 18.6 N-m (10 to 14 lbf-ft.).

11 Route the cable away from sources of electronic interference.

Mounting the Compass on a Pole

Using the included pole-mount adapter, this device can be installed on a standard 1 in. OD, 14 threads per inch,

pipe-threaded stainless steel pole (not included). The cable can be routed inside or outside of the pole.

NOTE: This device is designed for use with a stainless steel pole. Mounting the device on a plastic pole can

result in unintentional rotation that may affect the heading information.

in.) screw holes.

on the bottom of the compass.

into the mounting holes on the bottom of the compass.

to the mounting surface using the threaded rods

in.), you must use longer threaded rods (not

, flat washers

, spring