Garmin TR-1 Gold Руководство пользователя - Страница 13

Просмотреть онлайн или скачать pdf Руководство пользователя для Морская система GPS Garmin TR-1 Gold. Garmin TR-1 Gold 38 страниц. Throttle actuator
Также для Garmin TR-1 Gold: Руководство по эксплуатации (9 страниц), Краткая справка (2 страниц), Инструкции по монтажу (7 страниц), Инструкции по установке (4 страниц), Краткий справочник владельца портативного компьютера (2 страниц)

Installation of the Deckmount and Tach

Fig. 11

Fig. 11-A

Step One: (Deckmount)

If the material you wish to mount the Deckmount

switch in is less than ¼" thick: Drill a hole 15/32

Diameter perpendicular to the surface. Unscrew

the bezel from the switch and leave one washer on

the neck. Put the switch button, with washer,

through the hole from below. Screw the bezel on

to the top and your done. Refer to Fig.11

If the surface you want to mount the Deckmount on

is thicker than ¼ inch, Drill a 19/32 hole through

the surface. Unscrew the bezel from the top of the

switch and remove the washers. Slide the switch

all the way through the hole from the backside of

the panel. Apply some silicone sealer/adhesive to

the barrel of the switch. Screw the bezel, with or

without a washer back onto the switch and slide the

switch back into the hole. It may be necessary to

tape or otherwise hold the switch in place until the

sealer/adhesive sets. Alternatively, you can make

a custom sheet metal bezel/mounting bracket for

the switch.

Note: Route the cable for the tach on the

opposite side of the kicker motor that you route

the throttle actuator wire

Step Two (Tach)

The Tach is the portion of the cable with a white antenna

end. The antenna end needs to be installed into your

outboard motor. The wire connector from the deck

mount/Tach switch is labeled number 1. It connects to the

E-H unit at connector number 1. Route the Tach portion of

the wire from the E-H unit back to the motor. Remove the

outboard cover. Route the cable through the grommets on

the front of your motor, then route the cable around the

motor to the spark plug wires. You will need to lay the

white or antenna end of the cable along side of one of the

spark plug wires in your motor. Keep the antenna end at

least 1" from either end of spark plug wire. Do not

stick the end of the wire into the boot of the spark plug

wire. Use tie-wraps to attach the antenna end of cable to the

Spark plug wire. (Fig. 11-A)

(After installation of your Autopilot, you will need to verify

your tach. Please refer to page 31, paragraph 2 for more

information).