Garmin 010-02346-00 Руководство по установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по установке для Морское оборудование Garmin 010-02346-00. Garmin 010-02346-00 19 страниц.

Connecting to Power Through an Ignition Switch

This method of connection is used most often on ski boats, wake boats, and similar sport or recreational

vessels where power to the engines is toggled often. For these installations, a quick standby and faster startup

time is desired so that music can be stopped and begin playing again as quickly as possible after restarting the

engines. When in standby mode, the stereo uses up to 200 mA, and you should connect the power wires

through a circuit breaker or manual switch to avoid draining the battery when you are not using the boat.

1 Consult this diagram to plan the wire connections.

Item Description

Yellow wire

Red wire

1 A fuse (not included)

Ignition or ACC switch

Black wire

15 A fuse (not

included)

15 A circuit breaker or

manual switch

2 Route all wires to the stereo wiring harness, the ignition or ACC switch, the circuit breaker, and the power

source as necessary.

Do not connect the wiring harness to the stereo until after you have made all of the bare wire connections.

3 Install all of the necessary fuses on the red and yellow wires.

4 Connect the wiring harness to the stereo.

When you turn on the ignition switch, the stereo turns on along with other accessory electronics. When you turn

off the ignition switch, the stereo enters a low-power standby mode.

NOTE: When you are not using the vessel for an extended period of time, you should remove power to the

stereo using the circuit breaker or other manual switch on the yellow wire to avoid draining the battery.

Notes

You must connect this wire to the same power source as the ignition or

ACC switch.

You must connect this wire to the ignition or ACC switch before you

connect it to the same power source as the yellow wire.

You must install this fuse on the red wire before you connect the red wire to

the ignition or ACC switch.

Connecting the red wire to this switch allows the stereo to enter a low-

power standby mode when you turn off the engines, so it can start up faster

when you turn on the engines again.

Ground (-)

This fuse is required if you are not able to connect to power through a 15 A

circuit breaker

If a circuit breaker is not available, you must connect a 15 A fuse

yellow wire. You should also connect the yellow wire to power using a

manual switch, so you can remove power to the stereo when you are not

using the boat.

Apollo MS-WB670 Installation Instructions

on the