ALKOTA 210 Технические характеристики - Страница 5
Просмотреть онлайн или скачать pdf Технические характеристики для Нагреватель ALKOTA 210. ALKOTA 210 19 страниц.
Печатать страницу
As viscosity increases, the thicker oil can cause
delayed ignition, poor spray patterns, and
rumbling fires.
destroy fuel pumps, make certain that tank
openings are secure and moisture cannot
enter. In cold weather areas, frost build up will
occur in fuel tanks. As the weather warms it
turns to condensate, and the water will be in
the tank. Keep the tank clear of water, as
moisture reaching the fuel pump will cause
rust, and the pump will bind. A full fuel tank
will lessen condensation build up.
OPERATING
INSTRUCTIONS
PRE START-UP
The first time the machine is operated, after
repairs have been made, or if the machine has set
for a period of time (30 days or more) follow the
following procedures.
1. Check the tension of the belt per instructions
in MACHINE MAINTENANCE.
.
2
Read and observe all items in "SAFETY" and
"INSTALLATION".
3. The high limit safety switch is designed to turn
off the burner if the blower fails. Adjust the
high limit safety switch to 125°F.
START-UP
Refer to the MAINTENANCE SCHEDULE for
.
1
any maintenance to be performed before
operation.
WARNING: ELECTRIC
SHOCK HAZARD
2. ELECTRICAL: Connect the machine to an
electrically grounded circuit that is fused or
circuit breaker protected. Do not use any type
of adapter. If the correct type of receptacle is
not available, have one installed by a qualified
electrician.
Supersedes 10-00 Z08-00443C
As moisture will quickly
3. BELT (if so equipped): Make sure belt tension
and
condition
MAINTENANCE.
.
FUEL FILTER: Inspect fuel filter for
4
evidence of water contaminants.
5. FUEL: Use only Kerosene, #1 or #2 fuel oil, or
#1 Diesel. The use of incorrect fuel may result
in fire or explosion and severe injury to the
operator.
6. FUEL QUANTITY: Make sure the fuel supply
is sufficient to complete the job.
GENERAL
SPECIFICATIONS for the fuel tank capacity.
.
TEMPERATURE CONTROL: Adjust the
7
temperature
temperature. (if so equipped)
.
HIGH LIMIT SWITCH: The high limit safety
8
switch is designed to turn off the burner if the
blower fails. Adjust the high limit safety.
DANGER: DO NOT operate in a confined
area. Indications of inadequate ventilation
are headache, dizziness, burning eyes and
nose, nausea, dry mouth, or sore throat.
.
9
Adjust the temperature control to
temperature. (if so equipped)
CAUTION: DO NOT DIRECT EXHAUST TOWARD
ANY COMBUSTIBLE OR HEAT SENSITIVE
SURFACE SUCH AS BUILDING MATERIALS,
PAPER, PLASTICS, OR
AT LEAST TEN FEET AWAY FROM SUCH
ITEMS
WARNING: DO NOT OPERATE IN SUCH
AREAS
CONTAINING
AIRBORNE
COMBUSTIBLES.
PRODUCTS
SOLVENTS, PAINT
PARTICLES, OR UNKNOWN CHEMICALS
.
10
Turn the fan switch to the on position.
Do not start the burner unless a good flow of air
is coming from the heater.
5
is
as
specified
MODEL
section
of
control
to
the
desired
CARDBOARD. KEEP
VOLATILE
SUCH
AS GASOLINE,
THINNERS, DUST
12-03-03 Z08-00443C
in
See the
desired
OR
OTHER