Garmin Fishfinder 400C Руководство пользователя - Страница 14

Просмотреть онлайн или скачать pdf Руководство пользователя для Морское оборудование Garmin Fishfinder 400C. Garmin Fishfinder 400C 40 страниц. Flush mount kit instructions and template (multilingual)
Также для Garmin Fishfinder 400C: Краткое справочное руководство (2 страниц), Важная информация по безопасности (48 страниц), Декларация о соответствии (1 страниц), Руководство по установке (28 страниц), Руководство по установке (30 страниц), Руководство пользователя (21 страниц)

400c

nstallIng the

IshFInder

6. Mark the location. Using a 1/8" bit, drill a pilot hole

approximately 3/8" (10 mm) deep.

7. Attach the cable clamp using a 4 x 12 mm screw. Coat the

screw with marine sealant before installation. Repeat steps 5

and 6 using the other cable clamp.

8. Route the transducer cable, as needed, to the fishfinder. DO

NOT CUT THE CABLE. Avoid routing the cable with electrical

wires or other sources of electrical interference.

Drill pilot holes here.

Level

Align with the transom

bottom. The transducer

should extend /"

below fiberglass hulls

or /" below aluminum

hulls.

Keep it parallel with the water line.

Shoot-Thru-Hull Installation

To avoid drilling a hole to mount a thru-hull transducer, a

transducer can be secured with epoxy inside a boat (shoot-thru-

hull installation). This type of installation can provide better

noise reduction and allow you to use a higher Gain setting. For

a transducer to be mounted inside the hull (shoot-thru, not thru-

hull), the boat must be fiberglass, with no core. Contact your boat

manufacturer if you are unsure. Professional installation might be

necessary.

Some transducers are specifically designed to be mounted inside a

fiberglass hull. The standard plastic transom mount transducer can

also be mounted using this method. If using a temperature sensing

transducer, the temperature shown reflects the hull temperature.

Fishfinder 400C Owner's Manual