Garmin FUSION XS Series Руководство по установке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по установке для Морское оборудование Garmin FUSION XS Series. Garmin FUSION XS Series 13 страниц. Marine wake tower speakers
Также для Garmin FUSION XS Series: Руководство по установке (11 страниц), Руководство по установке (6 страниц), Инструкции по установке (4 страниц), Руководство по установке (6 страниц)
Печатать страницу
Subwoofer Wiring
When connecting the subwoofer to your amplifier or source, observe the following considerations.
• Speaker wire is not included with the subwoofer. You should use 12 AWG (3 through 4 mm
connect the subwoofer to the amplifier or source.
• The leads on the subwoofer are terminated using male spade connectors. You should use female spade
connectors (not included) to connect the speaker wire to the speaker leads for the best connection.
• The subwoofer features a dual 2 Ohm voice coil that can be configured for 2.1 operation (two speakers and
one subwoofer) when connected to a FUSION stereo with DSP capability
Operation, page
6).
• You can use the following table to identify the polarity of the leads on the speaker.
White
Gray with a black stripe
NOTE: Gray and white with a black stripe wires are connected to jumper terminals on the back of the
subwoofer. These wires must remain connected to the jumper terminals for normal use (4 Ohm) and should
be disconnected only when configuring the speaker for 2.1 operation.
LED Wiring
Connecting the LED Wires
You can control the color of the LEDs by connecting the LED color wires to ground. You can splice the ground
wire to multiple LED wires to customize the LED color.
NOTE: This feature is available only on the sports model.
NOTE: Instead of connecting the LED wires for one dedicated color, you can install a remote control to turn the
LEDs on and off, change the color, and create lighting effects. See your FUSION dealer or
for more information.
The black wire on the LED cable is terminated with a 4 mm female bullet connector, and the color wires are
terminated with 4 mm male bullet connectors. You can connect these to 4 mm bullet connectors on your wires
(not included), or remove the bullet connectors to connect to the bare wires instead.
1 Connect a positive wire to the black wire on the LED cable.
2 Connect a ground wire to the wire on the LED cable according to the preferred LED color.
LED Color
Red
Green
Blue
Yellow
Magenta
Cyan
White
3 Route the positive and negative wires, and connect them to a power source
Power, page
6).
XS Series Subwoofer Installation Instructions
LED Wire Color
Red
Green
Blue
Red and green
Red and blue
Blue and green
Red, green, and blue
2
) speaker wire to
(Configuring the Subwoofer for 2.1
Positive (+)
Negative (-)
support.garmin.com
(Connecting the LED Wires to
5