Garmin FUSION XS Series Руководство по установке - Страница 4

Просмотреть онлайн или скачать pdf Руководство по установке для Морское оборудование Garmin FUSION XS Series. Garmin FUSION XS Series 11 страниц. Marine wake tower speakers
Также для Garmin FUSION XS Series: Руководство по установке (13 страниц), Руководство по установке (6 страниц), Инструкции по установке (4 страниц), Руководство по установке (6 страниц)

Mounting the Speakers

Before mounting the speakers, you must choose a location following the guidelines above.

Before cutting the mounting surface you should verify that there is enough clearance for the speaker behind the

surface. Refer to the specifications for clearance information.

Do not apply grease or lubricant to the screws when fastening the speakers to the mounting surface. Grease or

other lubricants can cause damage to the speaker.

1 Route the wires from the source to the speaker location, away from sources of electrical interference.

2 Trim the template and make sure it fits in the selected location.

3 Orient the template so that the Fusion logo is right-side up on the template.

4 Secure the template to the selected location.

5 Using a rotary tool or jigsaw, cut the mounting surface along the inside of the line on the template.

6 Place the speaker in the cutout to test the fit.

7 If necessary, use a file and sandpaper to refine the size of the cutout.

8 After the speaker fits correctly in the cutout, ensure the mounting holes on the speaker line up with the pilot

holes on the template.

9 If the mounting holes on the speaker do not line up, mark the new hole locations.

10 Using an appropriately sized drill bit for the mounting surface and screw type, drill the holes.

11 Remove the template from the mounting surface.

12 Connect the speaker wires

13 If necessary, connect the LED wires

14 Place the speaker in the cutout.

15 Secure the speaker to the mounting surface using the included screws

NOTE: Do not over tighten the screws, especially if the mounting surface is not flat.

16 With the speakers mounted, hold the grille with the Fusion logo at the bottom, or at the 6 o'clock position.

17 Turn the grille counter-clockwise about 30 degrees, so the Fusion logo is at the 5 o'clock position.

18 Place the grille on the speaker, and twist it clockwise to secure it.

NOTE: Instead of twisting to install the grille, you can line it up so the Fusion logo is at the 6 o'clock position

and press to snap it into place.

NOTICE

while observing polarity

(LED Wiring, page

5).

(Speaker Wiring, page

5).

XS Series Installation Instructions