Garmin GNX Инструкция по установке - Страница 2

Просмотреть онлайн или скачать pdf Инструкция по установке для Морское оборудование Garmin GNX. Garmin GNX 48 страниц. Mast bracket
Также для Garmin GNX: Руководство по установке (28 страниц)

Печатать страницу

1. Installation Instructions

GNX

™

Mast Bracket Installation

Instructions

Important Safety Information

See the Important Safety and Product Information guide in the

product box for product warnings and other important

information.

Always wear safety goggles, ear protection, and a dust mask

when drilling, cutting, or sanding.

When drilling or cutting, always check what is on the opposite

side of the surface.

Contacting Garmin

Product Support

• Go to

http://www.garmin.com/support

information.

• In the USA, call 913-397-8200 or 1-800-800-1020.

• In the UK, call 0808 238 0000.

• In Europe, call +44 (0) 870 850 1241.

Tools Needed

• #2 Phillips screwdriver

• Drill and drill bits (if needed to secure the bracket to the mast)

• Mounting hardware (to secure the bracket to the mast)

Installing the Mast Bracket

Mounting Considerations

When determining the mounting needs for the bracket, observe

these considerations.

• You should select a mounting location for the bracket on your

mast where the bracket is not damaged by normal operation

of the boat.

• The sun cover fastens to the mast bracket using snaps on

the top and bottom of the bracket. If you plan to use the sun

cover, you must select a mounting location where both the

top and bottom of the mast bracket are accessible.

• The hardware needed to assemble the mounting bracket is

included with the bracket. The hardware needed to connect

your marine instruments to the mounting bracket is included

with the marine instruments.

• The hardware needed to secure the bracket to the mast is

not included, because this can vary based on your installation

needs. You must determine how to mount the bracket to your

mast and purchase the mounting hardware.

• The NMEA 2000

T-connectors and right-angle drop cables

needed to connect the marine instruments to your NMEA

2000 network are included with the marine instruments. A

NMEA 2000 backbone cable is included with the bracket to

extend your NMEA 2000 network to the assembled

instruments in the bracket. If the included backbone cable is

not long enough, you must purchase a longer backbone

cable.

Assembling the Mast Bracket

Adhere the gaskets included with the devices to the back of

each device.

The gasket has adhesive on one side, and should be

adhered to the back of the device, not to the mast bracket.

With the devices oriented in the same direction, secure the

device straps

to the devices using the threaded rods and

WARNING

CAUTION

NOTICE

for in-country support

thumbscrews

provided with the devices, and place the

devices into the front panel of the mast bracket

Secure the device straps to the front panel of the mast

bracket using the included screws

Assemble the NMEA 2000 T-connectors.

Secure the T-connectors to the included mounting plate

using the included screws and nuts

Connect the right angle drop-cables to the tops of the T-

connectors and to the devices.

Remove the thumb screws along one side of the devices

place the plate over the threaded rods, and secure the plate

with the thumb screws.

On the front panel of the mast bracket, place the rear panels

so the snap connectors align with the top and bottom of the

bracket.

Two of the rear panels have snap connectors that secure the

sun cover to the assembled bracket. If the snap connectors

on these panels are not at the top and bottom of the

assembled bracket

, you cannot attach the sun cover to the

bracket.