EN
NMEA 000 power cable
Female terminator
Connecting the GWS 10 to an Existing NMEA 2000 Network
1. Cut the cable that you routed down the mast to the appropriate length. Ensure that you leave the appropriate amount of slack.
2. Insert the bare-wire end of the backbone cable into the field-installable connector. Connect the wires to the field-installable connector as
shown in the following image.
NMEA 000 cable
3. Disconnect the male terminator from the backbone at an appropriate location.
4. Attach the field-installable connector to the gray in-line lightning arrestor.
NOTE: If lightning strikes the mast or the wind sensor, the in-line lightning arrestor helps prevent the electrical charge from damaging the rest of the
instruments connected to the NMEA 2000 network.
5. Connect the in-line lightning arrestor (connected to the field-installable connector) to a T- connector.
Configuring the GWS 10
Refer to your Garmin Chartplotter or marine instrument owner's manual for specific instructions on accessing the NMEA 2000 devices for
configuration.
To configure the orientation:
1. Select
Wind Angle Offset
Select the angle (in degrees) to adjust for the difference in orientation.
2.
Tip: The angles are configured clockwise around the mast of the boat. For example, 90 degrees is starboard while 270 degrees is port.
To adjust the filter settings:
1. Select
Wind Angle
2. Choose from the following settings to adjust the filter:
•
Off—turn off the filter to make the display more sensitive to changes in the wind.
•
On—select a higher number to increase how sensitively the display reacts to changes in the wind angle, or select a lower number to
decrease the sensitivity.
•
Auto—automatically adjusts the filter settings based on wind conditions.
3. Select
Wind Speed
GWS 10 installation instructions
-
+
T-connectors
A Basic NMEA 2000 Network with the GWS 10 Attached
Wiring the Field-Installable Connector
if you did not orient the GWS 10 facing the exact front of the boat.
Filter.
Filter.
GMI 10
In-line terminator
NMEA 000
drop cable
NMEA 000 backbone cable
Field-installable connector
In-line lightning arrestor
NMEA 000 bare wire
red
GWS 10
NMEA 000 drop cable
black
white
blue
➄
bare wire
EN–
Печатать страницу