Garmin Reactor 40 Kicker Руководство по установке - Страница 18

Просмотреть онлайн или скачать pdf Руководство по установке для Морское оборудование Garmin Reactor 40 Kicker. Garmin Reactor 40 Kicker 29 страниц.
Также для Garmin Reactor 40 Kicker: Руководство по конфигурации (6 страниц), Руководство по конфигурации (8 страниц)

Connecting the Autopilot Components to an Existing NMEA 2000 Network

A dedicated helm control is not included in all autopilot packages. If you install the autopilot without a dedicated

helm control, the autopilot CCU must be connected to the same NMEA 2000 network as a compatible Garmin

chartplotter to configure and control the autopilot system.

You should apply dielectric grease to the pin holes on the cable connectors to prevent corrosion, especially if

you are using the autopilot system in saltwater.

1 Determine where to connect the CCU

backbone

2 In the location where you plan to connect the CCU, disconnect one side of a NMEA 2000 T-connector

from the network.

3 If necessary, connect a NMEA 2000 backbone extension cable (not included) to the side of the disconnected

T-connector to extend the NMEA 2000 network backbone.

4 Add an included T‑connector for the CCU to the NMEA 2000 backbone by connecting it to the side of the

disconnected T‑connector or backbone extension cable.

5 Route the included drop cable

If the included drop cable is not long enough, you can use a drop cable up to 6 m (20 ft.) long (not included).

6 Connect the drop cable to the CCU and the T-connector.

7 If needed, repeat steps 2 through 6 for the helm control (optional) or a compatible Garmin chartplotter.

Connecting Optional NMEA 2000 Devices to the Autopilot System

NOTE: You can connect optional devices that are not NMEA 2000 compatible to the helm control through NMEA

0183

(NMEA 0183 Connection Considerations, page

1 Add an additional T-connector (not included) to the NMEA 2000 network.

2 Connect the optional NMEA 2000 device to the T-connector by following the instructions provided with the

device.

Configuration

The autopilot must be configured and tuned to your boat dynamics. You can use the Dockside Wizard and the

Sea Trial Wizard on the helm control or a compatible Garmin chartplotter to configure the autopilot.

See the included configuration guide for more information on configuring the autopilot.

NOTICE

and the helm control (optional)

to the CCU and to the bottom of the T-connector added in step 4.

20).

to your existing NMEA 2000