Garmin GTX 320A Руководство по установке - Страница 14

Просмотреть онлайн или скачать pdf Руководство по установке для Морское радио Garmin GTX 320A. Garmin GTX 320A 43 страницы. Garmin gtx 320/320a transponder installation manual
Также для Garmin GTX 320A: Руководство пилота (4 страниц), Руководство пилота (8 страниц), Руководство по установке (37 страниц)

Trim coax outer insulation back 0.50"

Trim braid (not center conductor or insulation) back 0.25".

Strip Insulation back 0.120".

Place the ferrule over the coax braid, flush against the coax outer insulation before performing the

next step if the outside diameter of the coax braid is smaller than the inside diameter of the center

connector sidewall opening.

Insert cable (center conductor, dielectric and shield braid) through the sidewall of the connector

and solder the center conductor to the center pin of the connector.

When using low loss cable it may be necessary to flatten the solid wire center conductor slightly so it

can fit the slot on the RF connector center pin. When soldering, avoid applying excess heat to the

connector body, and center conductor insulator.

Heat the outside of the connector sleeve and at the same time apply solder between the braid and the

sleeve. Continue to apply heat until the solder flows evenly.

Install 50

Insert connector cap and tack solder in two places.

Page 2-4

Rev M

Figure 2-1 BNC Connector Assembly Drawing

Matching Bushing.

NOTE

GTX 320/320A Installation Manual

190-00133-01